1990 Chevy 1/2 tone regular cab with the 8-ft. bed and the 5.7L 350 takes a 72in. dirveshaft. That measurement is from end to end, not yoke to yoke. It's 64 and 3/4 weld-to-weld.
The 72 Challenger had 3 different gear ratios depending on the motor the car came with. If the car came with the 225 or 318 cu. in. motor it had 2.76 or 3.23 gears in the rear end. If it was a Rallye Car with the 340 cu.in. motor it had the 3.23 or 3.55 gears. The approximate ratio can be determined by marking both the a wheel and the driveshaft; turn the wheel one complete turn and the number of times the driveshaft rotates is the ratio of gears in the rear end.
1/72 of 1 inch = 0.3528 millimetres.
72 inch
0.01388
1/72 of an inch
Font size is by fractions of 72 of an inch. For example, if a font is 14 pt., then it is 14/72 of an inch, or 7/36. A font size of 72 would be a full inch tall.
There are 72 points per inch. So 1 point would be 1/72 of an inch or 0.0139 inches.
72 Centimeters = 28.35"
A 72-inch diameter circle has an area of: 28.3 square feet.
18 pieces. 48 / 16 = 3 72 / 12 = 6 6 * 3 = 18 pieces
It takes 1 hour, as the car is travelling at 72km per hour.
72 inches is 182.88cm (2.54cm per inch).