because so it want miss the smaller hole if it was one ya digg
the acids in the oil eats the pan over time
Over tightening the drain plug.
probably when its pressurized and theres a hole somewhere
You need to have the hole tapped out to a larger size, and put in a larger drain plug. Or, you can have the whole oil pan replaced, which is more expensive
pressure in the sump caused by engine breather pipe being restricted or blocked is one cause for oil coming up through the dipstick hole
Coolant is getting into the ATF possibly through a hole in the oil cooler
if oil is blowing out dipstick hole, this indicates that the inside of engine and oil pan are pressurizing.check to make sure oil filler cap is venting and not clogged.if this is not the problem, the other cause is broken piston rings causing pressurization of engine
the cap is open
Drill a hole in the rock until you get to the oil. Insert a steel pipe into the hole, and pump the oil up from the bottom of the hole.
there is a open hole on the bottom of your trx250 in the casing. it is a 17mm size bolt that you have to unscrew. i am not sure how much oil to put back in but there you go. there is no oil filter
The hole is about the size of 1/8 drill bit and blows out on right knee when riding. Sounds like a breather. Should there be a pipe between the hole and the airbox?
In my 1995 Pontiac Bonneville the oil leaks out the intake manifold and drips onto the exhaust. An engine that has a gaping hole will hold no pressure.