answersLogoWhite

0

  • Birth Control Pill
  • Chevy Blazer S-10
  • Ford Expedition Eddie Bauer
  • Menstruation

What causes a miss in a 1992 s-10 blazer?


Top Answer
User Avatar
Wiki User
Answered 2011-03-15 13:21:17

IT could be a bad plug or a bad plug wire or mabye the distruber cap

My 1992 had issues with the dist.cap collecting condensation and would run with a foul bought a Napa Gold and all has been well

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still have questions?

Related Questions

Where is the ECM located in a 1992 Chevy S10 blazer?

The ECM on a 1992 S10 Blazer is located below the glove box.


Can parts from a 1993 S10 Blazer be used to repair a 1992 S10?

yes, most of the parts are interchangeable from the blazer to the pick up.


Will a 4.3 z engine from a 1992 s10 blazer fit in a 2000 s10 blazer?

It would bolt in but you would have fuel injection problems.


Where does the speedometer plug in on a 1992 s10 blazer?

at the tail of tranny


1992 s10 4.3 vortex the same as a 1996 s10 blazer?

block and heads are the same but not the computers


What is code 43 1992 Chevy S10 blazer?

knock sensor


Will a 1992 Chevy s10 transmission fit in a 1984 Chevy 4x4 blazer?

Not unless the 1992 is 4x4.


How much ac oil in new compressor on 1992 s10 blazer?

8oz.


Where is the solenoid on 1992 Chevy s10 blazer?

The starter solenoid is attached to the starter.


Why would hot air come out of the defroster and vent work but not the heater on 95 S10 blazer?

What causes heat to only come out of the defrost and vent but not the floor of a 1995 S10 Blazer?


What is the wheelbase for a 1985 S10 blazer?

what is the wheel base for 1985 s10 blazer


Will a transmission out of a 1995 s10 blazer fit a 2000 s10 blazer?

Yes


How much will it cost to repair a transmission on a 1995 Chevy Blazer S10?

I live in DE and they wanted 12 to 15 hundred to do my 1992 blazer.


Where is the proportioning valve on a 1992 Chevy blazer s10 4x4 located?

under the master cylinder.


Will a motor from a 1990 s10 blazer fit in a 1995 s10 blazer?

Yes it will fit.


What causes low oil pressure in 95 s10 blazer after idling for a few minutes?

the coil


Where is the fuel pump on 1992 Chevy blazer s10 Tahoe 4x4?

its in the gas tank..you have to drop the tank to get to it!!!


Where is the 1992 s10 blazer interior light in-line fuse?

There should not be one for the interior light.


How do you adjust the idle on 1992 Chevy s10 blazer?

You don't, it is done by the ECM (Engine Control Module).


Where is the fuel pressure regular located on a 1992 chev s10 vortec 4.3 blazer?

It is in the throttle body.


How do you change front wheel stud on Chevy 1992 s10 blazer?

The front wheel stud on a 1992 Chevy Blazer S10 can be changed by jacking the vehicle up, removing the wheel, and unbolting the caliper. The rotor assembly can then be removed, and the wheel stud pressed or hammered out of its seat.


What is the timing degrees for a 91 s10 blazer 4.3 2wd?

on a 91 blazer s10 4wd


Where is fuse for power windows in Chevy s10 blazer?

We need to know what year that S10 Blazer is.


Will an alternator from a 2000 Chevy blazer fit a 2002 s10 blazer?

An alternator from a 2000 Chevy blazer will fit a 2002 S10 blazer with a little fabrication.


What causes your 1995 s10 blazer to miss and cut out?

Could be in need of a tune up consisting of replacing spark plugs, spark plug wires, distributor cap, rotor, air and fuel filters.