Headlights Tail and Brake Lights
Dodge Ram
Ford Explorer XLT
Turn Signals and Hazard Lights

What causes no brake lights 1999 dodge ram have flashers turn and running lights?

171819

Top Answer
User Avatar
Wiki User
Answered
2005-09-03 15:53:14
2005-09-03 15:53:14

Possibly blown fuse, bad brake light switch, or blown brake light bulbs.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Please check the Brake light switch....The brake light switch should be located near or on the brake pedal (up on the stem of the brake pedal)

The only thing that will work with key OFF is the brake lights,head lights and emergency flashers. Dome light will also work.

Often this type of behavior is caused by a bad ground for the lighting circuit. Check the ground circuit for the brake lights.

on the brake pedal under the dash is a brake light switch. that when you depress the brake it turns your lights on. you might wanna check that

I have a 03 gran prix and my brake lights doesn't come on when I go to brake

Generally brown is used for running lights, green for right turn and brake, yellow for left turn and brake.

Acura legend ls ( First Generation)G1At night the rear brake lights won't stay ON ...........My rear brake lights would go out only when I pull the E- Brake down?Caution to Driver's behind you use FlashersDaytime running light relay(0099) is mounted on the rear seat of the car (Canada)

check the fuse, brake lights have their own, & check the brake switch at the top of the brake pedal

TRY TURNING THE EMERGENCY FLASHERS ON AND OFF A COUPLE TIMES THEN CHECK YOUR BRAKE LIGHTS. WORKED FOR ME.

brakes and running lights have separate fuses. check the fuse then check the brake light switch under the dash

I would check the running lights for one with a short. I had the same sort of thing with my trailer and I spent way to much time troubleshooting the brake and signal wires. Turns out a running light bulb connector was grounding out on the trailer and messing it all up.

Blown fuse, broken wire, or short in your running lights circuit. you may also not have dash lights. Brake lights, T/S are on a separate circuit. Hope this helps, Mike

what causes the rear lights to stay on while engine is running. the car is park

If the brake lights stay on when the car is not running on most vehicles, including the 1994 Dodge Intrepid, there is probably a short somewhere in the wiring to the brake lights. The first place to investigate this problem would be the wires along the firewall that control the brake lights. Also, check the brake light switch above the brake pedal.

have you check the tail light fuse to see if it is blown. other possiblly is the headlight switch.

Bad brake switch. Typically located at the top of the brake pedal.

The BOO (Brake On/Off) Switch may need to be replaced. If it is bad, it would cause the brake lights to NOT illuminate when the brake pedal is applied.

running or parking lights, or plate light, but that is singular.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.