0
What causes the gas pedal in a 1995 Blazer to stick when stepped on hard like to pass someone?
Wiki User
∙ 17y ago
Your cabel, the one that is conected to your throttle may needed to be looked at.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
What causes the brake light on a 200 Chevy blazer to come on?
If nothing is holding the pedal down then the brake light switch is at fault.
What causes the brake light to come on 2000chevy blazer?
Usually in every vehicle the brake lights come on when the brake pedal is pushed in. There is a switch connected to the pedal in some way to make the light switch on.
How can you use stepped in sentence?
His shoes were a mess after he stepped in the mud. She won the race after she stepped up her pace. He stepped up to the plate, swung the bat, and hit a home run. She stepped on the gas pedal and sped away. His parents were very proud of him after he stepped up to do the right thing by telling the truth.
Where is the location of the brake light switchon1997 Chevy blazer?
Directly above the brake pedal.
Where is access to obd on a 2003 blazer?
The 2003 Chevrolet Blazer OBD 2 port is on lower edge of dash; right of parking brake pedal
What causes your truck to accelarate when is on?
The accelerator pedal. Also known as a gas pedal.
How do you replace the brake light switch on a 99 Chevy Blazer?
you can find the switch on the back of the brake pedal.
Could someone tell why you get a rattling noise when stepped on the pedal even at slower speeds Toyota carina 96?
I had a 96 Carina e with a knock/rattle from the front end. Turned out to be anti-roll bar linings. Cost
1986 s10 blazer has a hard brake pedal and you can hear air as the pedal gos down?
power booster behind master cylinder sounds like they may be the problem
Why makes a 1983 Chevy S10 Blazer 2.8 V6 stall when the accelerator pedal is depressed?
Your 1983 Chevy S10 Blazer might stall when the accelerator pedal is depressed because of a clogged or dirty fuel filter. Gas that is mixed with water or condensation from the tank can also cause this issue.
What car control causes a change in velocity?
The gas pedal, the brake pedal, and the steering wheel all do.
How do you change brake light switch on a 97 Chevy blazer?
Follow the below steps to replace the Brake Light Switch on Chevy Blazer:1) Open the Chevy Blazer's driverdoor, and move the driver's seat as far back as it will go. Lean under the dashboard with the flashlight, and shine the light on the brake pedal arm to locate the brake pedal switch.2) Unhook the brake pedal wiring pigtail from the Chevy's brake pedal switch by hand. Unbolt the old brake pedal switch from the mounting bracket using the box wrench set.3) Remove the old brake pedal switch by hand. Insert the replacement brake pedal switch into the brake pedal bracket. Bolt the switch in place with the box wrench set.4) Plug the brake wiring pigtail into the replacement brake pedal switch by hand. Readjust the driver's seat, and close the door. Hope this helps.
