answersLogoWhite

0


Best Answer

You should have someone pull off the hubs and check your bearings to see if they need to be replaced or just repacked

User Avatar

Wiki User

โˆ™ 2006-03-02 03:27:23
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: What causes thumping sound from rear wheel while braking that slows as car slows and no thumping if braking while in reverse even happens after installing brand new rotors and pads?
Write your answer...
Submit
Related questions

What happens when you shift from drive to reverse with out stopping?

car will jerk forward and then go in reverse


What happens when a Diode is in reverse breakdown?

It broked


What happens to the magnetic orientation of rocks as the poles reverse?

There is nothing -_-


What happens when you put your car in reverse while the engine is off?

It goes into reverse gear, nothing else.


What happens if you reverse DC polarity of a lamp?

nothing


What happens if the forward and reverse reactions are equal?

Equilibrium.


What is reverse pitch propellers?

Reverse pitch propellers allow the propeller blades to rotates to an angle that produced thrust in the opposite direction direction of flight. This allows propeller driven aircraft to stop faster than they would with braking alone.


If a dc motor is operated in 4 quadrants what is the mode dof operation in each quadrant?

The 4 Quadrants are;1 FORWARD DRIVE2 REVERSE BRAKING3 FORWARD BRAKING4 REVERSE DRIVE


What happens to rocks along a fault line?

reverse fault


What happens to the magnetic orientation of rocks as the pole reverse?

There is nothing -_-


What happens when lightning strikes a magnet?

The Magnet Poles reverse.


What P R N D B in Toyota vitz means?

Park Reverse Nuetral Drive B (Regenerative Braking Mode) good for long descents


Do reverse faults create fault-block mountains?

Yes reverse faults create mountains. this happens by 2 plates collide.


95 acura integra standard transmission noise when going into reverse?

that happens to me also, but to avoid the noise before going into reverse put in in first then put it in reverse that'll work!


What is the loud thumping noise on a 2004 z71 Tahoe when you put it in reverse?

Several malfunctioning parts on a 2004 Tahoe can cause it to make noise when put in reverse. The transmission fluid should be check to see if there are any pieces of metal in the fluid. The transmission should be taken to be properly diagnosed to avoid the need of expensive repairs.


What happens when you reverse the current in an electromagnet?

The magnetic field reverses direction.


What happens if battery put reverse?

It Wont fit in o-o


Why does 93 Oldsmobile Cutlass make loud moaning noise in reverse only and you can feel vibration in steering wheel but it stops when brakes are slightly applied?

When a 1993 Oldsmobile Cutlass makes a loud, moaning noise in reverse it is possible that the reverse gear in the transmission is getting ready to go out. The braking system should be looked at too, because of the vibration.


How do you replace the fuel indicator on a low rider?

pulll the fule indicator straight up and out. remove the wires and reverse this procedure when installing the new indicator.


What step in the water cycle happens after water is evaperated?

Condensation happens after water is evaporated. It is the reverse process of evaporation.


Will salt water freeze faster than tap water?

no, but happens reverse.


What happens to the diode if it has high piv?

It can be connected in high reverse bias voltage .


What P R N D S B?

Park Reverse Neutral Drive Super Braking


Do passenger jets have engines that can move the aircraft in reverse?

Reverse thrust- similar in a sense to similar use on ships and rr equipment, is used for braking purposes and backing up=on the ground. no conventional aircraft (Blimps helicopters and some stol-like things and VTOL excepted) can fly backward.


How do you replace a mower battery cable?

remove the cable from the battery, follow it to the other end, ground or starter, reverse the same for installing a new one,