0
On the factory radio wire harness of a 2002 Oldsmobile Alero what color do you connect to the remote wire of your amplifier?
Wiki User
∙ 17y ago
If you are unsure of the remote wire, locate your radio fuse and get a fuse connector. hook it into the fuse and run it wherever you need it. all the remote does is swith the equipment on and off.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
When installing a new radio in a 1989 Dodge Caravan winfinity factory radio how do you integrate it with factory amp or bypass the amp?
if you are using an aftermarket wiring harness hook up the remote turn on wire on the new radio it should be blue with a white stripe to the harness also has a blue and white stripe and plug it in this wire turns on the factory amplifier if you are not using a harness you will have to locate the internal amplifier wire of the radio and connect that to the remote turn on on the aftermarket radio = answer = the inernal apm power wire is white on the black wire harness ANSWER if you dont want to use the factory amp. just run new speaker wires to each speaker.
Do you get a small amplifier that you can install in a car door and connect on the speaker line that comes from the radio?
No. You buy a waring harness and connect it to the car wiring and the amp to the speakers there behind the radio.
ZX2 Factory Radio Has No Sound But Power?
If your are using a wire kit, you need to connect the blue and/or blue/white wire from the harness to the blue/white wire from your radio. Now if you have cut your wires you will have to locate the one wire that will turn on your factory amp.Good Luck!!!!
What do you do if your aftermarket radio wiring harness does not match the factory wires?
Many aftermarket companies sell adapters for aftermarket wire harnesses. They have the original factory harness at one end and you cennect that to the harness that came with the radio. Check your local car audio installer.
Where do you connect the red power wire for aftermarket radio in new gm?
That depends. There should be two red power wires on the back of an aftermarket deck. One will be 'constant' power, the other will be 'switched' power. The 'constant' one always has power, so that radio stations and other settings aren't erased when the vehicle is turned off. I'm assuming you're not using an adapter harness to connect the aftermarket deck directly to the GM radio harness.(always the preferable option) Most of the time(when not using an adapter harness) I will locate a pre-existing wire in the dash that is 'constant', and tap into that for the 'constant'. The 'switched' power can be connected to the factory radio's 'switched' power source. You'll have to figure out which wire that is in the GM harness and connect to that, or (not so ideally) cut that wire and connect it to the deck.
When installing a new radio in a 1989 Dodge Caravan winfinity factory radio how do you integrate it with factory amp or bypass the amp?
if you are using an aftermarket wiring harness hook up the remote turn on wire on the new radio it should be blue with a white stripe to the harness also has a blue and white stripe and plug it in this wire turns on the factory amplifier if you are not using a harness you will have to locate the internal amplifier wire of the radio and connect that to the remote turn on on the aftermarket radio = answer = the inernal apm power wire is white on the black wire harness ANSWER if you dont want to use the factory amp. just run new speaker wires to each speaker.
How do you bypass the factory amplifier on a 2001 suburban and where is the amp located?
I'm not sure how to bypass the amplifier, but it is located behind the glove box. There are two harnesses that connect it to the radio. The bottom harness is removed by squeezing the ears and pulling off. The upper harness' release is on the rear facing side and is more difficult to operate. I used a small box-end wrench to take off the mounting bracket, then you can pull the amplifier out and turn it to see the clip.
Where is the factory Bose amplifier On Off lead in a 2002 Oldsmobile aurora?
The on/off lead is a light pink on the first harness on the Bose amplifier (bigger clip). Keep in mind this is the 8 speaker premium sound package but im sure the 6 speaker package is also the same. The amplifier is located on the back wall in the trunk on the left side, just remove the plastic cover!
Do you get a small amplifier that you can install in a car door and connect on the speaker line that comes from the radio?
No. You buy a waring harness and connect it to the car wiring and the amp to the speakers there behind the radio.
What color is th remote amplifier turn on wire in a factory Pontiac grand am gt monsoon harness?
it should be the blue and white wire
Radio wiring diagram 2007 Chevy silverado?
Here is the info in your vehicle: Radio 12v red/white + radio harness Radio Ground black - radio harness Radio Ignition (GMLAN Serial Data) Radio Illumination yellow (dimmer) + radio harness Factory Amp Turn-on same as power antenna wire Power Antenna white + radio harness LF Speaker +/- tan - gray +,- radio harness or amplifier Notes: If equipped, the amplifier is under the rear of the center console. At the amplifier, the left subwoofer wires are dk. blue/white (+) - lt. green/black (-). The right subwoofer wires are dk. green (+) - lt. blue/black (-). RF Speaker +/- lt. green - dk. green +,- radio harness or amplifier LR Speaker +/- brown - yellow +,- radio harness or amplifier RR Speaker +/- dk. blue - lt. blue +,- radio harness or amplifier
Where is the radio harness that you can hook your aftermarket radio into?
Usually when you get the radio the place you bought it will have a wiring harness that will fit the car. If not then go to a radio installation shop and ask for one. This will then plug right into the factory car harness and then you connect the radio to this harness. That's it. Good luck.
Why does after market radio have no sound after installation on 2000 grand prix?
do you by chance have the factory BOSE system? if so it could be that you did not wire up the Bose amplifier i believe its the pink wire comming off the small harness that does not get plugged into the aftermarket harness Adam
What does the pink wire in the wiring harness connect too?
the harness
Replaced stock stereo in 01 Civic EX and now factory keyless entry do not work How to fix?
Go to www.installdr.com and they will walk you through it. You need an adapter for a non-Honda radioAnswerPagan Audio (on Ebay) as well as AUTOTOYS on the internet sell "Metra" wiring harness for around $10 ~ $15 That will match your factory harness so you won't have to cut and spice and also have a secondary plug which will plug into the car's factory plug and allow you to retain factory alarm/keyless entry and dome light. AnswerThe harness Pagan Car Audio (Ebay) does not work for a 98. The pigtail harness they sell has a "male" connector and so does the factory keyless entry/alarm harness from the car. You must cut the ground, 12V continuous (yellow) and the ignition (red) wires from both harnesses and connect them for there harness to work, a pain. AnswerI had to keep my stock radio harness in the dash when i replaced mine. The keyless entry sensor is located in the harness.
Can someone teach me where to connect my remote wire for my car stereo if i don t have a amp?
if you are talking about an aftermarket radio's amp turn on wire then without an amp you can just cap it off. if the harness used to connect to new radio to your factory wires has a blue antenna/factory amp then you can connect it to that provided the new radio doesnt have a second blue wire for that purpose.
Does the 2004 dodge durango have a plug in under the dash for the factory trailer wiring harness?
The factory wiring harness for the trailers will plug in under the back of the vehicle in the area of the spare tire, the harness plugs into the wiring harness for the tail lights.
