Oops, I meant which of the five wires? I have subsequently discovered that the IAT is connected to the yellow/red stripe wire. I needed to know this in order to install a "gas saver" resistor on this line. Be advised that such an item does not work. When you cut the IAT wire you will cause your check engine light to come on continuously. To correct this, with the ignition off press and hold the odometer zeroing button. Continue holding and turn the ignition to on for a few seconds. Release the odo button and start the engine. The light should go off in a few more seconds.
The IAT sensor on a Toyota Tacoma is found inside the air intake. The sensor clips into the plastic tubing used for the air intake system.
The high beam wire on the 2004 Toyota Tacoma is red with yellow stripes. You can use a test light to determine which wire is active when the high beams are on.
Connected to the master cyclinder.
The 2004 Toyota Tacoma has 16 valves.
The 2004 Toyota Tacoma has a 5-speed manual.
The 2004 Toyota Tacoma has an inline 4 engine.
The 2004 Toyota Tacoma is a gas-powered vehicle.
The 2004 Toyota Tacoma has double overhead cam (DOHC).
The 2004 Toyota Tacoma's turning circle is 36.7 ft..
The 2004 Toyota Tacoma is 15 ft. 4.4 in. (184.4 in.) long.
The 2004 Toyota Tacoma runs on regular unleaded.
The height of the 2004 Toyota Tacoma is 5 ft. 4.1 in. (64.1 in.).