how to install automotive tachometer on a snowmobile
The instructions should be with the meter. If not contact the manufacturer
Use an inductive pickup on plug-wire #1, and connected to tachometer located in vehicle.
i have no clue, im trying to figure out how to install a tachometer to a 93 civic cx hatxhback, cuz my car dont even have a stock tach, and i got a autometer tach. if u find n e thing out help me outand send me an e mail firstname.lastname@example.org
The Tach sensor is connected to the positive terminal of the ignition coil at least that where my laser's factory tachometer is connected to. I believe Ghia and Sport models 1981 - 1984 have factory installed tachs
Remove the instrument panel cover. Remove the tachometer retaining screws. Remove the tachometer cable from the back of the tachometer. Reverse the process to install the new tachometer.
How do I install a aftermarket tachometer on a 1995 dodge ram truck
Yes you can.
To install a tachometer in a '87 Monte Carlo SS, run the tachometer wiring around or through the dash board. Next, connect the tachometer's black wire to the battery ground of the vehicle.
you dont need to cause it has a factory tachometer
a tachometer, wire and wire terminals
If you don't have a distributor on your car, you will need to get a tach adapter for your car. So that you can get an rpm signal from your car to the tachometer.Hey dude, here's how to connect the green wire from your tachometer: Tach output is obtained from PCM (powertrain control module) which is a 104 wire connector, and is located behind the passenger side kick panel. Look for pin number 48, which is usually an orange wire with a white stripe.(4.6L is = 4 ppr)Your best bet is to check out the autometer's web site which provides most all the information you might need. If you can't find the info email autometer tech support.Go to test connector inside the fusebox under the hood, it is a t-shaped plug. Tach is the terminal on the top left of the T. The wire under the terminal is white or white/red.