answersLogoWhite

0


Best Answer
Copy

feul filter may be

Answerhave coils checked.. AnswerCHECK YOUR VACCUM HOSES. MAKE SURE THEY ARE NOT HARD OR CRACKED AnswerMy 93 was the same way. Had the injectors cleaned on a workbench style injector cleaner (ASNU) and it ran great afterwards. The shop provided before and after measurements from the flow of the injectors - the difference was huge!
  • The same thing happened to me 1998 and it turned out to be a cracked plug. I must have turned to hard while installing it.

You need to ensure that the spark plugs were all gaped to the manufactures measurements, also ensure that you have all the spark plug wires on in the appropiate locations.

I had the same problem also, it was caused by cracked plugs from being installed too tight and also a defective ignition coil.

User Avatar

Wiki User

โˆ™ 2010-11-06 14:57:11
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +5 pts
Q: What could be wrong with a 98 Bonneville that runs really rough even after you have replaced plugs and wires?
Write your answer...
Submit

Related Questions

Why does a 1993 Pontiac Bonneville keep dying?

There could be several reasons why a 1993 Pontiac Bonneville keeps dying. A couple of reasons could be a dirty air control valve or bad spark plugs.


Does a 2002 Pontiac Bonneville SSE have glow plugs?

No, only diesel engines have glow plugs. It has spark plugs.


What is the firing order for a 2002 Pontiac Bonneville 3800 engine?

What is the firing order for points and plugs on a 2002 Bonneville?


Why would a 1989 Pontiac Bonneville continue to cut off at stops if the check engine light is on but you have replaced the starter battery coilpack spark plugs and wires?

I HAD A 1990 BONNEVILLE I HAD THE SAME PROBLEM WITH.IT TURNED OUT TO BE THE CRANK SENSOR.ITS BEHIND THE HARMONIC BALANCER. HOPE THIS HELPS


Where are the spark plugs located on a 1989 Bonneville?

Just follow the plug wires to the chambers and you'll find the spark plugs.


1995 Bonneville do you have to disconnect a motor mount or something to move the motor to be able to replace the rear three spark plugs?

I own a 1994 Bonneville and replacing the back spark plugs was not too bad, there is enough room and with a socket extension you will have no trouble.


Why does the 1988 Chevy s10 blazer 2.8 idle really good but when driving it start sputtering real bad and the fuel pump has already been replaced?

Assuming the fuel filter has also been replaced, a bad distributor cap and or wires and spark plugs could do that also.


Misfire on a 1996 Bonneville you changed spark plugs and wires What is your next option?

Fuel injectors or coil


What would cause 1997 Bonneville 3800 that is only firing on two cylinders have already replaced coil packs still does the same thing any ideas coil packs are not firing well 1 of them is?

Bad plugs? Bad wires?


Why would there be back firing in a 1996 Oldsmobile Ciera after the fuel pump has been replaced?

Could be as simple as fouled spark plugs.


Car jerks during acceleration . its a 1999 Pontiac Bonneville?

I just had the same problem on my 99 bonnie I found a bad plug wire, so I replaced all the wires and plugs now runs grear now. Hope this helps.


How do you change the plugs on a 93 Bonneville?

You takes out the old ones and puts new ones in the holes as are left behind.


Replaced fuel filter plugs idles fine but sputters cuts out when accelerating what could cause that?

Intake manifold air leak or you need to put some fuel injector cleaner in. Did you gap your plugs correctly?


have an 07 night train the rear cylander isn't fireing I replaced the coil pack wires plugs and chec?

have an 07 night train the rear cylander isn't fireing I replaced the coil pack wires plugs and checked the compresion still no fire what could it be? i'm hopeing not the brain


Why does my dodge neon 2003 only working on 3 cylinders instead of 4?

Could be plugs and wires (spark plugs) I had a mis-fire (only 3 cylinders running) and I replaced my spark plugs and wires, and it worked. I have a 2003 Dodge Neon SE. Cheers!


How do you set timing for 2002 Mazda 626?

I had a shop change my belts and plugs and now it runs really bad. I think that when they replaced the belts that they moved it out of time.


What is the reason for broken crankshaft?

really bad spark plugs probably could fix with bj weld


Can fiber optic tree plugs be replaced?

yes indeed but as long as the plugs are made up of notrogenic-solution.


What could cause sputtering cutting out in a 1993 Plymouth Grand Voyager replaced the fuel pump fuel filter air filter plugs idles great?

could be a vacuum leak


Why won't my 96 jetta start i replaced coil distributor i have spark going out of coil but nothing going to plugs?

Even though you replaced the coil, it may be bad. You should test that first. If the coil is okay, it could be that the ignition wires need to be replaced.


Car sputters when accelerating?

There are many issues that can make a car sputter when accelerating. For instance, the sparks plugs may need to be replaced. Another issue could be that the exhaust could be clogged or there could be a bad injector.


Why does your corsa utility 1.4 you jerk when driving?

Spark plugs need to be changed. had the same problem and it disappeared when I replaced the plugs.


What causes a 98 Firebird to skip really bad and sometimes stall Replaced crankshaft sensor plugs wires ignition module Still having problems What else could it be?

look at the fly wheel to see if it has any missing teeth that might be the problem


How long to change the spark plug?

Spark plugs are really easy to access and should not take longer than 15 to 20 minutes and that's going really slow. I replaced mine in 5 mins.


What else could be wrong if 2 cylinders are misfiring after getting water into the motor through the intake after the spark plugs and ignition coils have been replaced and it is still misfiring?

I really hate to be the one to tell you the bad news but it is possible that you have bent some valves. Take the spark plugs out of the missing cylinders and run a compression check on those two.