0
What could cause a 1998 Toyota Sienna to hit hard and sputter a bit when the transmission downshifts from 3rd to 2nd or 1st Could it be an electronic adjustment or is the transmission failing?
Wiki User
∙ 17y ago
It seems to me that it could be the transmission going bad I am not 100% sure. Visit www.siennaclub.org I am sure you can get better answers there.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Perhaps the most serious weakness of the Agricultural Adjustment Act was?
failing to assist tenant farmers and sharecroppers
How do you adjust the clutch on a 1980 Camaro?
The 1980 Camaro does not have a clutch adjustment. If the clutch is not operating right, then there is something in the clutch system that is failing.
What could be causing a loud hum from the transmission of a 2005 Musting at low RPM's?
The loud hum could be caused by some of the teeth going out on the transmission or that the transmission is failing.
Why would your car seem like it should down shift then stall out?
Failing transmission
Why would a car jerk while driving at high speed?
could be failing transmission
Why does my reverse just grind when i shift in to reverse?
This is a manual transmission car, I presume. If it's an auto, you have a big problem! Grinding could mean that something inside the transmission is failing. Or it could mean that your transmission fluid is low. OR, it could mean that your clutch is worn or is out of adjustment. Grinding usually means that the clutch is not disengaging properly when you push the clutch pedal, or perhaps, a synchronizer has failed. Whatever the case, If I were you, I'd get the car to my mechanic and have her looked at.
Who long will a mercedes-benz CVT transmission last before failing?
There is no way to know how long it will take for the transmission on a Mercedes Benz CVT to fail.
Can an erratic speedometer indicate failing transmission on a 1994 Mercury Sable?
If your speedometer is cable driven and not electronic, it sounds like the cable needs to be lubricated. You remove the cable from the back of the speedometer and pull out the inner cable and slide it back in while lubericating it with some speedo grease.
Why does the automatic transmission in my 1991 ford explorer make a grinding noise when i shift it into reverse.?
The A4LD transmission is the most common failure on early explorers. It's very likely that your transmission is failing.
How much does it cost to replace the transmission in a 2000 jetta?
I have a VW Jetta 1.8t with the tiptronic transmission and it cost about $3500 to have rebuilt. I was bummed, but these transmissions are notorious for failing.
What does metal shavings in a trasmisson pan mean?
It means the transmission is failing. It is caused by gears grinding or rubbing.
91 pathfinder auto transmission is failing when you put it in drive it goes in gear for a bit and drives then you press the gas and it revs but goes nowhere Is this a blown transmission?
yes it is
