0
Add your answer:
Earn +20 pts
Why would the battery light stay on after the ignition is turned off on a 1986 Nissan pickup?
The voltage reg is sticking and will run down the battery.
Where is the starter relay on a 1987 Nissan Pickup and is it the same as the ignition relay?
follow the wire from the positive side of the battery it will lead you to it
Is there an ignition module on a 1993 Dodge d150 pickup truck?
It is part of the computer behind the battery.It is part of the computer behind the battery.
Diagram ignition wiring 1987 Mazda pickup?
Color coded instructions on how the wiring should go in my pickup truck ignition
How to Replace ignition switch 1984 Chevrolet pickup?
Where can I download instructions for replacing the ignition switch tumbler on a 1984 chevy pickup?
1993 Chevrolet pickup starter wont engage when you turn the ignition on. the battery is good and i put a new starter on?
check your wiring, if all your wiring is good then test your ignition relay, if its not the starter, not the battery, and not the wiring there's only one thing left. Good Luck with the repair
I have a 1988 Chevy Cavalier. I replaced the Alternator and Battery and also changed a linkable fuse between the alternator and battery. The test still reads no output to alternator. Any ideas?
?ignition control module/pickup
My 1984 Nissan pickup will not charge the battery. I have replaced the alternator and put in a new battery.?
Check your ignition fuse,its in the fuse box,also,your fusible link could be burnt or melted,its connected to your positive battery cable,if burnt or melted,then its your problem.
Where is the ignition switch on a Mazda pickup?
by the steering wheel
What causes the ignition switch to rotate without powering up the ignition system and not starting on a 1984 Chevrolet pickup with tilt steering?
If your battery is fully charged and the connections are clean and tight, the problem is probably that the contacts in the switch are corroded or worn, meaning your ignition switch will have to be replaced.
How do you remove ignition cylinder from 1975 Chevy pickup?
You will need to remove the retaining ring from the top of your 1975 Chevrolet pickup truck ignition cylinder. Slide the ignition cylinder out and remove the wiring harness. Reverse the process to install the new ignition cylinder.
How doi remove ignition without key from 1986 Toyota pickup truck?
Begin by removing the retaining ring at the top of your 1986 Toyota pickup truck ignition switch. The ignition switch will slide out. Remove the wiring harness from the back of the ignition switch.
