answersLogoWhite

0

  • Chevy S-10
  • Nissan Quest
  • Door Panels and Handles
  • Ford Explorer Eddie Bauer

What do you do about a 2000 Nissan Quest side-door handle that broke off?

User Avatar

Wiki User

βˆ™ 2005-07-12 19:17:27

Best Answer
Copy

Call your Nissan Dealer, they should be able to order that for you. I have a 1997 Nissan Quest, and I ripped the side-door handle off in an accident, I went to the dealer and they ordered it for me. However, it took over 3 months for me to get the part, because it has to be a special order with Nissan in Japan.

2005-07-12 19:17:27
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Add your answer:

Earn +5 pts
Q: What do you do about a 2000 Nissan Quest side-door handle that broke off?
Write your answer...
Submit

Related Questions

When is a timing belt changed on a Nissan Quest?

My timing belt broke at 120k miles on my '01 Quest. I don't think it's an interference engine, as we turned it over several times while trying to diagnose.


How much should a dealer charge to change spark plugs on Nissan quest?

It doesnt matter what the dealer charges for the plugs, its what he is going to find broke and ream you out for that other stuff.


1988 Nissan 300zx The drivers inside door handle stopped working the plastic piece that holds the rod right next to the handle itself broke what do you do to fix the problem?

you need to take the white plasic piece off of the one that broke theres a large spring that will shoot you in the eye if you take the door handle one off so be careful. after that just lift the rod out and replace it, you can get them from Nissan or go to a junk yard and get them for a couple bucks they have these rods on eBay for $18 or so hope this helps


When to change a timing chain in 2005 Nissan Quest?

we put off the replacement of the timing belt on our 1999 Quest at the recommended 90K miles. It broke at about 100K and ruined the engine....I replaced the engine because I liked the vehicle so much, but the guy did a poor job and I continue to have trouble with it. Replace that belt if you like your Quest!


Cable for the hood broke on Nissan altima 2005?

cable broke release latch for the hood can't open it


How do you repair latch on tailgate of 1994 Nissan truck?

The handle on my 96 Nissan pick up broke. I called the dealer for a replacment and got a bad case of sticker shock. I found a replacement on ebaY for less then $20.00 It is not as nice as the original but works OK and I saved over $55.00


Why doesnt the heater work in 1999 Nissan sentra?

because it's broke


Who is A Tribe Called Quest?

a fantastict rap group that broke up on there rise to fame


How do you open the back hatch of 2001 Chevy Tracker?

my hatch handle is broke


How do you repair the inside door handle on a 1995 Ford F150?

if you are talking about just the handle is broke there is just one bolt in it you just have to to look in the hole where the handle was and take the bolt out get a new handle and put bolt back in


Of a glue that will mend a teapot handle that you think is made of phenolic material as it canbe exposed to high heat but you dropped it and the handle broke?

If the handle is in very few parts it could be renewed wit epoxy.


How do you release the tailgate if the handle broke while up?

Year, make and model would help.


The hose as broke on your Nissan Serena but you don't know the name of the part so you can order a new one?

the hose on my Nissan serna has broke it is the one that goes of the back of the thermostat housing to the temperature sender housing i need to know the name of this part so i can order a new one


Would a broke timing chain on 2004 2.4 Nissan Frontier cause motor to lock up?

yes


Parking brake handle cable is broke?

Then you will need to get it mended before the car can be considered roadworthy again.


My car was frozen shut. I broke the ice seal I pulled on the handle a little My handle now goes up further than it should and feels a little loose. Is it broken It's a 1987 Buick century by the way.?

Yes, it probably broke or bent.


How do you fix a driver side door handle if the door wont open on a 1995 ford Thunderbird?

The plastic on the inner handle has broke. One of the plastic gears just replace the actual handle (hard to find) get at a junk yard.


Why are my brake lights on 1995 Nissan Sentra staying on?

I have a 1995 Nissan sentra and the brake lights were stuck on because of a switch that broke above the brake. the mechanic said it happens to alot nissans


Why did the 2007 Nissan Altima rear sway bar break?

Mine broke on my 2007 Altima for no appearent reason.. It broke right at a connection point so I thinking this is a manufacturing defect. Mine broke on my 2007 Altima for no appearent reason.. It broke right at a connection point so I thinking this is a manufacturing defect.


Your shift indicator is not working on your Nissan altima 2002 what is wrong?

it's broke. if you car is not going into gear then it could be the trasnmision


Your cold water faucet handle broke in your tub and shower and after you replaced it now cold water continuously comes out of faucet how can you fix this?

Remove the handle, turn off the water with a wrench and reatache the handle in the correct position. Good Luck


What can you do if your car door handle broke on the passengers side of your 1995 Ford Thunderbird and you can not open your door?

I would find a replacement in a salvage yard and replace the handle. Or replace with door poppers


How do you handle a break up?

get all your friends and tell them you two broke up. surely they'll help you through it.


Why do the studs on my Nissan Quest keep breaking off We replaced the hub and now the studs have broke 3 times?

If you have aluminum alloy wheels a common cause for this is over torquing the lug nuts. This often happens when the shop uses an air driven wrench to put them on instead of hand tightening to save time.


How do you fix a broke exterior slider door handle for a Toyota sienna?

Replace the handle. You will need to remove the door panel to replace the handle. If you can't do this yourself take it to the dealer. They should charge you about 1.0 to 2.0 hours labor to do this, plus the part.