0
What do you do if your ignition switch is stuck in the on position?
Wiki User
∙ 9y ago
get a screw driver, shove it in, and turn it off. After, Go to a mechanic and get it fixed fast because it can result in a car fire if tinkered with to much.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Why escalade ignition switch does not turn?
The tumblers in the key cylinder have most likely become stuck in the wrong position and you will have to replace the ignition key cylinder.
How do you remove ignition key stuck in Chevy colbalt?
how to remove key stuck in ignition switch in Chevy colbalt
Do you have to turn on the switch to reset the tire pressure light?
Yes, the ignition switch must be in the ignition position -not- the accessory position.
What could be the reason for the key getting stuck in the 'on' position of the ignition in a 2003 Lincoln Navigator?
the tumblers in your key switch are failing replace them before long
How do you hot wire a 1988 Chevy Celebrity The ignition key is stuck in the accessory position and I need to start it and get it to the garage for a new ignition switch?
With the key stuck in the accessory position the steering wheel is locked and the gearshift is locked in the park position. Perhaps you should consider having a locksmith change the key cylinder where it is, or else have it towed to the garage.
What do you do if your ignition switch is stuck on the start position?
Hey Albert==It is probably in the lock cylinder. You may have to replace it. Get a manual on your car to find out the procedure. Goodluck Joe
Why won't my ignition switch turn back into lock position after changing the ignition switch?
Ur life suck that why
89 Jeep Cherokee Laredo Ignition key stuck in on position This is the second time last time cost 150 then after the warranty was up got stuck again?
In my case it was the ignition switch itself had overheated and seized up. Replace the switch (have to lower the column, disconnect the wiring plug from the switch, and remove/replace the switch.) Clean all connections to the switch, make sure they're connected solidly and not heating up again.
True or false the START ignition switch position activates only the starter motor?
It is false that the stat ignition switch position only activates the starter motor.
What do you do if the key is stuck in your Acura Vigor switch?
Replace your ignition lock assembly.
When the ignition switch is turned to lock?
you need to be more specific. i am going to assume you want to know in what position is the ignition switch in lock. usually it is 2 positions back from "run" but it is in whichever position the key comes out of the ignition.
How to reset an oil change light on a Jeep Patriot 2012?
1. Turn the ignition switch to the ON position. Do notstart the engine.2. Fully depress the accelerator pedal, slowly, three timeswithin 10 seconds.3. Turn the ignition switch to the OFF/LOCK position.1. Turn the ignition switch to the ON position. Do notstart the engine.2. Fully depress the accelerator pedal, slowly, three timeswithin 10 seconds.3. Turn the ignition switch to the OFF/LOCK position.
