The correct compression fittings.
Yes, it can, this is fairly common. Just use a PVC reducer to connect.
You can put up to a 2 inch pipe into a 4 inch. If you are putting 4 inch to 4 inch, either take out a section of the cast and put the PVC in or cut out a section and connect the PVC to the cast with rubber sleeves meant for this. You can use a saddle clamp for the 2 inch. It is a half round piece of PVC with a 2 inch connection in it. It is held on with two U bolts that go around the cast pipe. Put it where you need it and mark the 2 inch hole on the cast. Drill a series of 1/8 inch holes around this circle. when you get them all drilled, you can break out the plug. Try to keep it from falling into the cast pipe. Put the saddle clamp on and connect the PVC pipe as needed. Seal the saddle clamp to the cast pipe with plumbers putty.
NO. Although you may have plumbers PVC glue, it doesn't work well with flexible PVC like an inflatable. -Better products are Aqua Seal (available in Walmart Sports Dept) or 3M Marine Adhesive.
Most of the time it is 4 inch.
PVC will sag under the weight of clothing no matter how wide. Use a 3/4 inch pipe with the appropriate wooden dowel inserted through the tube.
Yes.
NO..copper,black iron, galvanized for gas pipe.never use plasticp solvents or glue.gas does not react well with other chemicals.
PVC is commonly used in plumbing
How to Boil Water in PVC Pipe I have been building wood steaming boilers, not PVC steam boxes, for about 2-1/2 years now and using PVC to boil the water in and produce steam. I use sch. 40 PVC and the correct cleaner and cement to go with it. PVC is rated at a much lower than it will really handle. I have run this steaming system for more that 12 hours at a time without any problems and complete safety. If you want more info about this, contact: woodsteamingsystems@yahoo.com. Ernie
Yes, if it is rigid PVC conduit approved for electrical installations. Don't use PVC water pipe as it will be rejected if inspected.
PVC is a type of plastic. Some toy makers use PVC to increase a toy's durability. PVC is hazardous for children when included in toys.
Depends on how much you need. Sometimes you can just use two wax rings. If that doesn't do it, you can use a PVC toilet flange and use it to make up the difference. Cut it off the right height and use a wax ring between it and the old flange. You cut the old flange out and extend the pipe and a new flange. If you put backer board down first and then the tile, you probably raised the floor level about 3/4 of an inch. Two wax rings with the black funnel insert in them should be enough to seal the toilet to the drain.