Want this question answered?
I started by removing the camshaft cover, then I realized the many other parts have to be removed before being able to succesfuly replace the sensor.... I also would like to know the procedure. Thanks
dirty exhaust system. All Matiz are like that. Could as well be rear weel bearings
The camshaft position sensor on a 1992 Buick Regal looks like the end of a ratchet.
I would like to know the samething!
The camshaft sensor for your vehicle actually looks like a small distributor, only with 2 wires coming from it. It is about as big as a mans outstretched hand. It is located on the top front of the engine near the water neck.
It depends on which sensor, O2/camshaft,etc. The O2 sensor is a straight metal sensor that is screwed into the exhaust. There is an upstream/bank1-sensor1 or down stream/bank1-sensor2 after the catalytic converter. A camshaft sensor is an L shaped, usually black sensor that is installed into the head closest to the firewall(bank1).
At the back of the engine, looks like a distributor!
I would like to know where the cam sensor is on a 1999 pathfinder and is there one or they calling it a crank shaft sensor The cam shaft position sensor is located in the distributor.
looks similar to the camshaft sensor, but it's located in the bell housing on the transmission on passenger side.
If you remove the distributor cap and rotor then you will see the cam sensor bolted on the distributor and it will have an electrical connector pluged into it.
The sensor is located behind the intake positioned just like a Chevy distributor. There is some wires coming off of it.
like all EFI engines, injectors become cloged with varnish-lime stuff. they have to be taken out and cleaned with a special macine for cleaning injectors.