On the 3.1L & 3.8L engines, the CMP sensor is located on the timing cover, behind the water pump, near the camshaft sprocket.
how to remove crankshaft position sensor from 91 Buick Regal
The crankshaft position sensor, on your 1992 Buick regal 3.1 liter, is located on the back of the engine. The crankshaft position sensor is on the inside of the engine cover.
Under hood, passenger side, lower engine area, below water pump, mounted on timing cover.
Where is the map sensor on a 2001 Buick Regal Ls
Where is the knock sensor located on a 1992 buick regal
Where is the headlight sensor for a 1999 buick regal? Its in the back, sike ;D
The 2000 Buick Regal 3.8L Crankshaft Position Sensor is located behind the harmonic balancer pulley.
On a 1993 buick regal it is on the side of the radiator.
Coolant Recovery Reservoir. There is no sensor in the coolant recovery tank on a 1998 Buick Regal.
On a 1994 Buick Regal 3.8L engine, the camshaft position sensor (CMP sensor) is located on the timing cover, behind the water pump, near the camshaft sprocket. Basic removal and installation instructions: # Disconnect the negative battery cable. # Remove the serpentine drive belt. # Remove the power steering pump, as outlined in Section 8 of this manual. # Detach the sensor electrical connector. # Remove the CMP sensor mounting bolt, then remove the sensor from the engine. # Inspect the sensor O-ring seal and replace as required. To install: # Position the CMP sensor and secure with the retaining bolt. Tighten the bolt to 8 ft. lbs. (10 Nm). # Attach the sensor electrical connector. # Install the power steering pump, as outlined in Section 8 of this manual. # Install the serpentine drive belt. # Connect the negative battery cable.
On a 1993 buick regal it is on the passager side of the radiator. Hope this helps