0
What else can you check on a 1994 Oldsmobile Achieva that is not firing after the crank sensor boots coil cover and module tested good?
Wiki User
∙ 17y ago
ignition control moduel common problem ..
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Where is the airbag module 1997 Oldsmobile achieva the light will not go off.?
The 1997 Oldsmobile airbag module sensor can be found below the dashboard on the drivers side. The airbag module should be labeled as such.
Where is the o2 sensor on an 1998 Oldsmobile Achieva?
the O2 Sensor Should be on top of your exhaust manifold
Where do you find the oil sensor on a 1992 Oldsmobile Achieva?
Plug has 3 wires.
Where is O2 sensor on 97 Oldsmobile Achieva 2.4 liter engine?
They are in the exhaust flow
Where is the Camshaft Position Sensor located in the 1996 Oldsmobile Achieva?
The Camshaft Position Sensor is located behind the Power Steering Pump.
Where is the crankshaft sensor located in a 1996 Oldsmobile achieva?
check main pulley area bottom by harmonic balance
How to locate and replace crankshaft sensor on 1996 Oldsmobile Achieva 2.4 liter engine?
did u ever figure it out?
Where is the crank shaft sensor on a 1995 Oldsmobile Achieva 4 cylinder?
well on the 6 cylinder, it is behind the crankshaft pully, try there.
Where is the map sensor on a 1997 Oldsmobile Achieva?
The map sensor is located next to the idler air control valve on the front of the motor on top. It has a vaccume hose hooked to it and one bolt holding it on with a bracket.
You just put engine coolant on your 1995 Oldsmobile achieva and the engine coolant light wont turn off?
The coolant level switch on a 95 Achieva has a sticking problem. If you tap the coolant tank near the sensor the light will go out
Were is cam sensor on 1986 s-10?
A cam sensor and crank sensor was not used on that year. If the engine is not firing then I would replace the ignition module that's in the distributor.
Your 96 achieva engine cranks but will not fire whats the problem?
There are several reasons why a 1996 Achieva engine cranks but will not fire. A few of the reasons could be a bad ignition control module, ignition coil pack, or a crankshaft position sensor.
