How do you replace fuel pump 92 Mazda pick up B2200?
no problem, you may have to change the motor mounts but its the same transmission...
The attached links should answer you're question. Kyrasis6 Mazdatruckin.com
I have a 92 b2200 with 325k miles. Ibought it brand new.
92 b2200 ,fuel injection psi should be 38 to 46 psi
If it is a factory fuel injected the fuel pump is in the gas tank, if it is a factory carburated the machanical fuel pump is at passenger side rear of the engine head.
91 or 92.............................you needing an engine?
The B2200 does not have "scan tool" capability. It does have a diagnositics port that can be used to throw out codes using the MIL light in the dash. There are about a dozen codes that at best tell you the obvious. There is lots of help on mazdatruckin.com that can help you diagnose your truck.
Hi Make sure it is not an after market pump, I put four after market pumps in my 92 until I was told to use a Mazda pump, all is running good.
no
yes, you will have to remove all the plastics from the 94 and put them into the 92, as well as the wiring.
Engines for the 86-89 B2000 and 86-93 B2200 are bolt in swaps. The short block from the 1st gen Ford Probe, and the 88-92 626 and MX-6 is the same, just bolt on you're cylinder head and accessories. Although I believe the B2600i has the same engine mounts the bell housing does not match and is not easily swapped. Mazdatrucking.com has additional information