0
What engines will direct swap on a 1985 Pontiac Fiero GT automatic?
Wiki User
∙ 14y ago
your car has a 2.8 v6.a direct bolt in is a 3.1 or 3.4 v6.both are based off the 2.8.you could say a 3.1 and 3.4 are 2.8 stroker motors
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
1988 Pontiac fiero gt with a automatic transmission that won't shift in reverse?
Check your Automatic Transmission fluid level
Does a 1985 Pontiac fiero have a transmission solenoid?
The automatic has one for the lock up torque converter
When was Pontiac Fiero created?
Pontiac Fiero was created in 1984.
How do you install the pilot bushing on a 1984 Pontiac Fiero?
Don't bother, neither the manual or automatic use it
How do you replace the alternator on a 1988 Pontiac fiero?
How do you replace the alternator on a 1988 Pontiac Fiero
What transmission came with the 4-cylinder 2.5 1986 Pontiac fiero?
The Automatic was generally known as the THM125 The manual was built by Getrag
How fast does a Pontiac fiero go?
Best top speed for a stock V-6 Fiero: 135 mph Worst: 115 mph Both Fieros were '85 GT's, the latter with an automatic transmission.
What is the stock horsepower of a 1985 Pontiac Fiero?
what is the smog and vaccum diagram for the 87 Pontiac fiero 2.5L 4 cylinder what is the smog and vaccum diagram for the 87 Pontiac fiero 2.5L 4 cylinder
Does your 1986 Fiero 2M6 automatic Trans have a governor if so how do you remove it?
Yes. The THM125C has a governor. The governor is just below the speedometer sensor. 1986 Pontiac fiero service manual section 125C page 22.
Does a 1985 Pontiac fiero 4 cylinder trans fit in a 1985 v6 Pontiac fiero?
Yes, sort of, The clutch is different.
What engines were orignally available in the Pontiac fiero?
Fieros came with 2 differnent stock motors, a 2.5 liter 4 cylinder, and a 2.8 liter v6
How do you replace rear oil seal on 1986 Pontiac fiero?
Most (not all) Fiero engines require the engine be removed from the car and the seal removed after that. The engines use a one piece seal in most engines. It is also possible to remove the transmission to do this, but either way you need to separate the engine and trans, pry out the old seal, and install new.
