Car Electronics and Lights
Turn Signals and Hazard Lights
Antique & Classic Cars

What fuse do you check for a turn signal on a 1990 Buick Lesabre?

012

Top Answer
User Avatar
Wiki User
Answered
2015-02-01 20:19:09
2015-02-01 20:19:09

If the signal light fuse is blown all the signal lights front and rear would not work. If you have one signal light out I would first suspect a bad bulb or bad connection.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


It is quite simple to replace the turn signal switch on your 1990 Buick LeSabre. The turn signal switch simply plugs in and out.


Probably 4-5 quarts check after 4


there could be a bad ground for the lights, or there is a short somewhere between your fuse panel and your light


fuel filter location in 1990 buck lesabre


On my 1990 Buick Lesabre it is on the underside of the dash in the middle of the car. Go to you ash tray and look under the dash. There will be a rectangular hole through the plastic and the plug will be in there.


I have a 1990 lesabre and im 90% sure its a 16 gal.


i have a 1989 pontica Bonneville and i bauht a 1990 Buick lesabre motor look the same but will it interchange with no problems


i have a 1989 pontica Bonneville and i bauht a 1990 Buick lesabre motor look the same but will it interchange with no problems


The 1990 Buick LeSabre air conditioner recharge valve can be found on top of the air conditioning compressor. The air conditioner recharge valve will have a blue top.


After consulting several sources, someone finally called a local Buick dealer who informed me that a 1990 LeSabre does NOT have a map sensor, it was the Mass Air Flow sensor that needs replacing.



The ECU is located behind the glove box upper left!


Under the coolant reservoir near the battery.



Leaking from? Hose Water pump Intake gasket


Loosen the tensioner bolt on your 1990 Buick LeSabre alternator. Slide the alternator to the left and remove the alternator belt. Remove the wiring harness from the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.


The 1990 Buick LeSabre oxygen sensor is located on the outside of the air cleaner housing. The oxygen sensor will be on the back side of the housing.




pictures of where to put power steering fluid in a 1990 buick lesabre


LOOK WAY UP UNDER THE DASH NEXT TO THE STEERING COLUMN



Electronic spark timing. May need module. Need more info.


Because it liked screaming at your mice while it was shirtless.........




Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.