The 2004 Nissan Sentra 1.8L take 5w - 30
how many liters of transmission take for Nissan sentra gxe
20mm * 1.5
take it to a glass shop they can do it for $ 40.00 max ...
take out the bulb
Dexron 3 or Nissan matic D. Same.
take it to a strret raceing shop!
about 2 litres of 5W 30
take it to the dealership, a nissan sentra takes atf fluid you can only buy at the dealership. For how much the fluid and tools for it cost it will be about the same price for them to do it
loosen adjuster bolts and take off belt......
Take it to Auto Zone and they will read them free.
One to two hours tops.
You need to take a wrench to loosen the oxygen sensor, then you will need to disconnect the cord. Once you have done that you will then pull out the old oxygen sensor.
definetly, bought a nissan sentra for my son, has 280 thousand miles on it, as long as you take care of the engine it will last. Engine is wonderful. runs superbly
you have to take the back seat out and it is inside of the gas tank.
NISSAN SENTRA'S AND OTHER NISSAN MODELS COME WITH A CHAIN. THEY ARE REPLACED WHEN THEY FAIL. TAKE NOTE:IF THEY FAIL.. HOPE YOU ARE AT IDLE WHEN IT DOES.. OTHERWISE IT MAY COST AN ENTIRE NEW CYLINDER HEAD.
There is a problem with the SRS in your vehicle. This is not a DIY repair. Take it to a professional ASAP.
It would depend on your level of competence.
Installing a starter on your 1998 Nissan will take approximately one hour. Removing and installing a starter is a very simple process.
It is important to use the right type of motor oil in a car to keep the car performing well. A 1999 Nissan Sentra GXE uses 5w-30 or 10w-30 engine oil.
No, the only way to drain a fuel tank is to take the tank off, or to syphin the gas out.
The mounting screws sheer on installation. The only way to remove them is to drill them out.
You have to take it loose from the front bearing then pry it out of the trans. Big Job
this happened with my 94 sentra just before the alternator died... i would take it to a parts store and have them test the battery and alternator.
i changed plugs on my 2000 sentra it should be the same procedure just loosen the screws to the four caps on the top of ur block and take them out and replace 1 by 1 if u have the paper i would go with pre-gapped plugs preferably platinum NGK
TTake them off ONE AT A TIME. If this is not enough information you need to take it to a garage.