answersLogoWhite

0

What happens if spline is not aligned when replacing front axle?

Updated: 10/25/2022
User Avatar

DavidKellerfb5955

Lvl 1
10y ago

Best Answer

It will not go together, you will not be able to get the retaining plate to match up with the bolt holes until the splines are meshed together.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What happens if spline is not aligned when replacing front axle?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Should you have your front end aligned after replacing the brakes?

No, doing a brake job does nothing to the front end.


ABS light comes on after replacing front suspension arm assembly?

You may have mis-aligned the sensor when you replaced it.


Should the front end be aligned after replacing the lower control arms on a 2002 Hyundai Elantra?

Whenever you get anything that has to do with the front suspension replaced you should go get your car realigned It is just good to make sure that you have it aligned.


1991 v2500 suburban how can you tell if it has a 28 or 30 spline in the front rear end?

Type your answer here... you will need to take the yoke off the front diff. and count the teeth on it. if it has 28 teeth its a 28 spline or if it has 30 teeth its a 30 spline


Why would the front end continue to shake on a Chevy Tahoe when braking and at speeds above 50MPH even after replacing rotors and pads?

Get you front end aligned, that should take care of the shakes.


Your truck leaks transmission fluid what is the problem and how do you fix it?

Replace the front seal which is located by the spline.


Why is a welch plug filled to the rear of a front yoke?

To keep dirt etc from entering the spline area.


What is the difficulty level replacing inner tie rods on 1999 Saturn SL Are there any surprises?

I've never had to replace tie rods, but I do know for sure that after it is done, you'll have to get your front end re-aligned.


What is the procedure for replacing a 2002 Buick Lesabre front strut?

Whats the procedure for replacing a 2002 Buick Lesabre front strut.?


Why is your cars front end still rattling after front suspension parts have all been replaced and all bolts have been tightened?

Did you have the front tires balanced and did you get the front end aligned??


Do you have to get your car alien after taking off your struts?

It is probably a good idea to get an alignment after doing any kind of work on the front end. If you have struts on the rear and take them off it is not as big a deal but, an alignment is a lot cheaper than replacing tires that wear prematurely because they are not properly aligned.


Replacing front wiper motor on a pathfinder?

where is the front wiper motor located on a 99 pathfinder