0
What if a oil pressure-relief valve get stuck in an open position?
Wiki User
∙ 9y ago
Then you'll experience frequent low oil pressure issues.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
What is the difference between a fail open valve and a fail closed valve?
Lets liken this to a garden hose, a hose in the normally open position has water flowing through it until it is closed by turning the spigot off, normally closed is the reverse. Oddly enough when it comes to an electronic relay the opposite is true, whereas the switch is in the open (normally open) position therefore having no current passing through it until a switch to close the circuit and allow current to flow. Normally closed has current flowing at all times until the switch interrupts it stopping the flow of electricity.
Hydraulic directional valves what is the difference bet open center and closed center?
A close center directional valve holds the position of the cylinder. This is because in its center position its 4 ports (4/3 way) are blocked. An open center valve on the other hand does not hold position in the center position. This valve is commonly used for motors because it handles system overloads or "shocks" to the system. All 4 ports are connected in the form of an H. This valve is sometimes called an H-mid position valve. I hope this answered your question. I'm a 1st year mech eng student so I might not have covered the details you were looking for.
What is the application of boiler stop valve?
Stop Boiler Valve (or Crown Valve) is installed on an outlet line of a boiler. It's purpose is isolation of a boiler from a downstream steam line. Its position may be either open or close, it cannot be used for throttling of steam.
High low side pressure and low hide side pressure?
Bad compressor valves most likely... If the expansion valve or orifice tube is stuck open it will cause this condition also.
What will happen if relief valve in hydraulic circuit fails?
when relief valve fails open the system will have nopressure resulting in weak hydraulic operation and if it fails closed( that is the relief valve stuck closed) itwill result in very high system pressure resulting in a very high load on the pump and the enginerunning or driving it.Muawiah Itum
Will a egr valve stop a car from starting?
If it's stuck in the completely open position, it can.
What happens when a P.C.V valve is stuck at open position?
If the engine were to backfire for whatever reason and the pcv valve is stuck open, the backfire could carry into the crank case and ignite the crank case fumes. I have seen valve covers blown off an engine from this situation.
Would it be possible for a stuck valve on a 1989 Cavalier Z24 to cause a Misfire?
yes. a valve in the open position will prevent compression, thus no combustion.
How do you fix a furnance main gas valve that is stuck in open position replaced thermostat and new wire no help worked fine last year?
You replace the gas valve.
Brinks combination lock is stuck in open position?
My brinks locked in the open position. What do I need to do to get it fixed
Blowback though air filter 1991 ford f150 5.0?
Blowback into a 91 F150 air filter could be caused by a bad PCV valve. Check the valve for it being stuck in the open position.
Can the water tank of a toliet overflow?
Sure if the valve gets stuck open and the flapper get stuck closed.
How do you stop your murrary lawn mower carb from overloading?
If by "overloading" you mean flooding (too much fuel), two reasons are (1) the carburetor needle valve is "wide open" or the float is stuck in the open position.
How do you wire a sprinkler control valve?
In the open position
Why does it run like choke is stuck then dies blowing gas out of line Briggs and stratton?
It could be that the spark need to be replaced. Other reasons could be that the carburetor needle valve is opened too far, or the float is stuck in the open position.
What causes temperature gauge in car hot?
StUck in open position
Does a ecg valve stop a car from starting?
It is possible if it is stuck open, but highly unlikely.
