answersLogoWhite

0


Best Answer

The low and medium speeds run thru a resistor. The high speed runs thru a relay. The relay or possibly the switch itself may be bad.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What if your heater only blows on low and medium it shuts off when turned on high?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

When you turn left on occasions the motor shuts off?

well that means that your car just BLOWS


When you turn your sterring wheel your engine shuts off?

when the sterring wheel is turned sharply to park, the engine shuts off


1993 cadillac deville heater blower wont stop even with the car turned off?

Open hood . Disconnect blower module located near blower fan. Disconnect, if blower shuts off, repalce module


What do you suggest for a heater blower that either will not work at all or works after the ignition shuts off and runs the battery dead?

Pull the fuse.


What devices shut down immediately if a short circuit occurs?

A circuit breaker shuts down and can be reset. (A fuse does not "shutdown", it fails, or blows, or breaks and cannot be reused.)


Chevy impala air condition problemsIt blows warm airI recharged it with a dye but cant find a leak.Took it in twice was low on refrigerant they recharged it but same problem.?

Your probles lies in either the heater switch,to command the selinoid to shut down the valve for the hot coolent,or the selinoid its self.Some where along the line the valve that shuts down in the heater line,to stop the hot coolent from entering the heater core is not closing.May be the shut off valve it's self . As you say..Air is on ,and i still get hot air. so heater switch ,(from hot to cold),selonoid,shut off valve??


The temperature control module in your 1997 ford explorer 8 cylinder is constantly in high heat the switch for air flow works but if you switch to ac it blows hot air however the max ac blow cold air?

You have a broken temp blend door in your heater/AC case. The reason it blows cold when you switch to MAX is because in the MAX position, the heater control valve shuts off coolant flow through the heater core. You will need a new heater case, because the door is inside the case and is not available separately. You had better replace the blend door actuator as well, because that is what I have found is causing the door to break to bgin with. The stops wear out in the actuator so that it begins advancing too far in one direction or the other and it breaks the doors.


I changed out thermostat in Z71 Suburban and heater still won't get hot why?

Check for a heater flow valve in the heater hose they can rust shut easily it is a valve in the heater hose that opens when you turn on the heat and shuts when its not in use, if not then probably the core is plugged a radiator flush might help but you may need to have it cleaned and repaired.


Is the an electric heater with auto shut-off?

Yes, all electric heaters are required to have an emergency circuit breaker which shuts the unit down in the event of overheating.


What could be wrong with your car if it sometimes shuts off right after you turned it on but when you turn it on again nothing seems wrong?

souns like a misfiring.


Why does the blower fan work on speeds 1 and 2 but shuts down on 3 or 4 and then does not work on any speeds?

Two possible issues The motor may be bad and the control shuts down when it is turned up to protect the control The control is bad


Should the air conditioning shut down in a new Subaru Outback when the clutch is depressed?

If you mean that the a/c shuts down or blows hot air when the a/c button is depressed then no it should not be doing that................