It's the bearings, the axle halves are held into the rear end at the ends. The bearing is pressed on to the axle and held on with a retainer plate. Sometimes after wear the bearing will become loose and the axle will begin to slip out. In the middle of the rear end the axles are splined and simply slip into the ring and pinion gears.
the axle is a shaft that goes into your rear end from one side with the wheel bolts on it and the other connecting into you rear end differential gears.
what is rear end axle ratio
The number of times the driveshaft turns for each turn of the rear end gear. For example, a 3.55 rear end gear would turn once for every 3.55 rotations of the driveshaft.
Inside the rear axle.
The 9.25 rear axle is a Chrysler corporate axle, it is not a Dana.
It is in the center of the rear of the axle.
Pinto and mustang II integral rear axle
Axle grease is used for the axle bearings that support the axle shafts. Rear end fluid also known as gear oil which is used in the rear differential to lube the ring and pinion gears.
How does the clip for rear end axles come out?
What type of rear end do you have?
probably because it has alot of miles on it or some one drove it hard the stock rear axle's were kinda week