A Canister Purge Valve is generally opened when the vehicle's ECM (Engine Control Module) applies a voltage to the valve. This valve controls how much (and when) fuel vapor is allowed to leave the fuel tank and be re-injected into the throttle body. The vehicle's ECM measures many factors (O2 levels, Exaust, Coolant temperature, etc.) to determine how much of this vapor can be re-injected, To ensure proper air/fuel mixing in the manifold. The purpose of the (Carbon) canister is to allow storage of fuel vapors when the engine is not running. Fuel vapors tend to stick to the carbon pellets in the canister, which is then picked up and used as soon as the engine is started.
P0443 - EVAP control system CANISTER PURGE VALVE CIRCUIT MALFUNCTION - VPWR circuit open - Evap canister purge valve circuit shorted to ground - damaged EVAP canister purge valve - EVAP canister purge valve circuit open - EVAP canister purge valve circuit shorted to VPWR - damaged PCM
Cannot locate canister purge valve on a 2001 pontiac sunfire 2.2
where is the canister purge valve located on a 03 chevy venture
The canister purge valve on a 98 Eclipse is located on the front of the car. It is on the right corner of the bumper.
The purge valve on the Malibu is located on top of the charcoal canister that is mounted on the side of, or in close relation to the fuel tank. Usually on the same side as the filler neck. This purge valve is not to be confused with the purge valve solenoid which is located on the intake manifold. If for some reason you can not find the purge valve/canister just locate the solenoid on the intake manifold (which will have an electrical plug and one vaccum line attached to it.) and trace the vaccum line under the car to the canister. As stated above...it is there that you will find the canister purge valve.
The canister vent valve is located near the fuel tank. The canister purge valve is located on the engine.
Canister purge valve is located under the air cleaner assembly, remove the aircleaner and the airintake hose, remove air filter, underneath in air cleaner housing are 2 7/16 nuts,remove and take housing out. canister is underneath. valve closes to canister is the purge solenoid.
The canister vent valve is located in back close to the fuel tank. The canister purge valve is located up front on the engine. If you're looking for the purge valve, look for a black plastic vacuum line under the hood that has a green dust cap on it. Follow that black line back to the engine. It will be connected to the purge valve.
You should be on the charcoal canister.
locate it next to engine
Assuming this is a 4.3L engine, the canister purge valve is located on top of the engine on the drivers side towards the back.
most likely in the evap canister.