answersLogoWhite

0


Best Answer

The rubber end on the spark plug wire.

User Avatar

Wiki User

8y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is a spark plug boot?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove a spark plug when the wire came out the spark plug?

If you mean that the wire came out of the boot, then pull the boot off of the spark plug and use a spark plug socket to remove the spark plug.


How do you pull spark plug wires on 2001 Chevy Impala?

Give the spark plug boot a twist to free it from the spark plug then pull it off of the spark plug by the boot.


What is a plug boot for a Chevy Tracker 1999?

That is the rubber boot that is on the end of the spark plug wire that goes onto the spark plug.


What would cause one spark plug wire to arc to the engine at the spark plug boot?

bad spark plug wire.


How do you get the spark plug wires off your spark plugs?

Pull on the boot.


How do you replace a spark plug in a Nissan 1991 Pathfinder?

Sparks plugs are replaced by disconnecting the battery, removing the spark plug cable and boot, and by removing the old spark plug. Next put in the new spark plug, attach the boot and cable and reconnect the battery.


How do you get the cable plugs off spark plugs?

The factory service manual says that to get the spark plug wire off of the spark plug: Twist the boot about a half turn to loosen it from the spark plug and then pull it off using the boot. Don't pull the spark plug wire to remove it as you may find yourself pulling the wire out of the connector. Pulling it off by the boot may also leave the connector on the spark plug.


How do you change the spark plugs on a 1998 ford 4.6 engine?

Remove the coil pack for each cylinder. On the bottom of the coulpack is a spark plug boot. Under the boot is the spark plug.


How do you remove spark plugs on boulevard cruiser?

Pop the hood open, remove the filter to the carburator, remove 1 spark plug wire boot at the front right side while facing the engine, remove the spark plug, add the new spark plug as well as the spark plug wire boot.


How do you remove the boot from the spark plug?

Gently twist the boost from left to right as you pull it off of the spark plug.


How do you check spark plug in lawn mower?

You pull the ruber boot off the top of the spark plug , take the plug out, put boot back on the plug, touch steel part of the plug to steel on motor,pull motor over while watching the gap on the plug if you see spark it should be ok if no spark do the same with a spark plug you know is good to make sure it is the plug. Hope this helps


Are spark plug boots the wires?

No. On "conventional" ignition systems, i.e., those with typically a single ignition coil and a distributor with distributor cap, the spark plug boot is that portion of the individual ignition wire, running to each spark plug, that terminated the ignition wire at the spark plug and provides the wire's electrical connection to the spark plug. In newer, "plug on coil" systems that do not utilize a distributor and wires, and that are characterized by having an individual ignition coil mounted atop each spark plug, the boot is that portion of the ignition coil that pushes down over and on to the spark plug. Some few designs use a replaceable boot. Most incorporate the boot into the coil assembly.