0
What is a sump screen I need to change an oil pump on 1993 suburban and I'm not sure what this is?
Wiki User
∙ 17y ago
The oil pump pulls oil up from the bottom of the oil pan and pumps it through the passages in the engine to the bearings and hydraulic lifters (if any). The tube that goes from the bottom of the oil pump into the oil pan is covered with a screen to keep out any potential large "chunks" of anything that got into the engine. The screen is called a sump screen and can usually be cleaned and re-used when the pump is replaced, provided that the screen is still in good shape.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How many quarts of oil does a 1993 GMC suburban need?
5 QTS. with new filter
1993 suburban heating?
Heater lines to rear are leaking and I need temporary, emergency bypass.
Where is trans screen on 1993 s10 blazer?
You need to drop the transmission oil pan to gain access to the screen.
How do you change brake shoes on a Chevy Suburban?
if you need to ask just take it to midas
Why there is a need to change the old computer screen to and led screen?
Yes because then it is a lot clearer
How do I open hatch on 1993 GMC Suburban 1500 when control won't unlock it Do I need to replace a fuse If so where is it located?
use your key
Do you need a press to change u-joints on a 1994 Chevy Suburban?
No All you need is a good working vise, 4 inch or better
How do you change fuel pump on 1989 gmc suburban?
you need to drop the fuel tank and pull it out of the tank o.k.
At what mileage do you change the timing belt in 2001 Chevy Suburban?
It does not have a timing belt, It has a chain and it don't need changed.
How many quarts of oil does a 2003 Chevrolet Suburban need for oil change?
The 2003 Chevrolet suburban requires five quarts of oil in the motor. The oil filter should be filled with oil, when changing it.
Nissian quest 1993 Water pump?
trying to change the Water pump on 1993 Quest Van? Need help.
1996 Suburban Remote once you change batteries do you need to reprogram If so how?
You only need to reprogram your radio presets, and set your clock. The computer needs no action on your part.
