Begin by tightening the head bolts on each corner of the head. Next, tighten the center head bolts. Tighten the bolts on each end of the head and move towards the center.
The Honda had bolt tightening sequence begins with the head bolts on each end of the head. Tighten the head bolts moving to the center, alternating from and to end.
The cylinder had bolt tightening sequence should begin by tightening the head bolts on each end of the head. Tighten the center head bolts. Work towards each end of the head, alternating back and forth.
The tightening sequence for the head bolts on a Peugeot 106 1.1 is to begin at 1 and of the head. Move to the opposite end of the head. Alternate back in forth until you reached the middle.
What are the torque specifications and the tightening sequence of the cylinder head bolts on a 1996 Saturn SL1?
The Haynes manual I have doesn't mention any need to re check. As the bolts are "angle tightened" I would have thought it unlikely that they would require a check.
Head bolts should be tightened most of the way in a star-shaped pattern. Bolts should then be tightened completely following the same pattern as the first tightening.
http://wiki.answers.com/Q/What_are_the_torque_settingsand_tightening_sequence_for_the_cylinder_head_bolts_on_a_kia_sedona_2.9 the cylinder head bolts on a kia sedona 2.9?"
Torx T-55. A torque angle meter should be used to install them the correct number of degrees on final tightening. These head bolts are TTY (Torque To Yield) and are actually stretched beyond their elastic limit when installed. New head bolts must be used on reassembly or gasket failures are likely.
by tightening bolts and screws down there is a Phillips head and a flat head for a - looking nail a flat head for a + looking nail a Phillips head.
maruti 800 2002 tightening torques of cylinder head
For the 1992 Chevy S-10, 2.2 liter, first tighten the cylinder head bolts to 40-47 ft. lbs. If you're using new bolts finishing tightening them to 54-61 ft. lbs. If you're using the original bolts, finish tightening them to 61-69 ft. lbs.