Stat is located within water outlet at bottom of top hose. Remove any component that blocks access to the stat. Drain rad at petcock or pull end off of lower hose.Remove water outlets 2-3 bolts, clean old gasket, observe how stat sits into housing then remove stat, clean and dry surfaces. Install stat in the same direction old one was, apply sealer to gasket and install outlet with bolts. Snug bolts EVENLY to avoid cracking the housing. Fill rad and run with rad cap off for 20 minutes topping coolant and bleeding out the trapped air. Done. I hope this helps you. Mark
What is the procedure for replacing the belt tenison pully on a 97 Bonneville v6 3.8 engine
It's under the throttle body housing. I'm looking for an answer on how to take the housing off to get to the thermostat
take off compressor remove the following pieces and replace with new parts as there nay be metal particles in the system . accumulator , evaporator , orifice tube and high pressure hoses
97 Grand AM Try replacing the radiator.
thermostst may be sticking
Starter has no voltage or insufficient to turn engine, possibly bad solenoid or something wrong with connections.
loosen the bottom bolt with a 13 mm swival head socket, do not remove the bolt all the way, take out the top one and the thermostat housing will slide out and then remove the thermostat.
The temperature sensor is located in the thermostat housing which is on the drivers side of engine, behind the throttle body near the top of the engine
What is cylinder head torque specifications for 97 Chevy lumina 3.1 v6
yes it will fit
== ==
How do I replace thermostat on 97 Ford van