0
The engine will run smoother and exhibit much less bearing wear than one without.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What is the advantage of a counterweighted fron a ordinary crankshaft?
reduced vibration, especially on tick over
Where is crankshaft?
Where does a crankshaft sit
What does the crankshaft sensor read on a 1996 Ranger?
Crankshaft position and crankshaft RPM
Can you weld the crankshaft pulley to the crankshaft?
no
How do you fix a damaged crankshaft?
A damaged crankshaft will need replaced.A damaged crankshaft will need replaced.
Where is the crankshaft sensor for a 1995 gmc jimmy?
The crankshaft sensor is by the crankshaft pullie (the balancer)
What is nitriding of crankshaft?
Nitriding is a chemical hardening process in which the part is heated in a furnace, the oxygen is vacuumed out, and nitrogen is introduced which penetrates the entire surface. The depth of hardness is dependent upon the time the crankshaft is exposed to the gas. Typically, a nitrided crankshaft will have a hardness depth of about .010 - .030. Nitriding is a low heat process compared to Tuftriding, but it shares the advantage of avoiding the introduction of localized stress zones as in induction hardening.
What is the purpose of the crankshaft in a petrol engine?
The crankshaft converts the linear motion of the piston into rotation of the crankshaft.
What is difference between centre and overhung position of crankshaft?
A center crankshaft has the crank located?æin the middle. An overhung crankshaft, also known as a side crankshaft, has it located to the side.
How do you take off the crankshaft?
How do I get to the crankshaft of a 1991 camero RS
Crankshaft position sensor on a SHO?
Yes there is a crankshaft sensor
Where is crankshaft sensor located on 2007 Hyundai tiburon?
crankshaft? what crankshaft? I think thats the engine connector you're pulling
