0
What is the average amount of money to replace a coolant flange and flushing the system for a VW Jetta?
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What is the Average amount of water used when flushing the toilet?
1.6 - 3.5 gpf
How much coolant is needed in an average nuclear power station?
Depends on the amount of fuel remaining. Usually at 78% and at 780 Degrees, A Reactor requires 480 Kilo Litres of Coolant [Water] per Day.
Does flushing a toilet not use water?
Each flush of a toilet uses the same amount of water.
How do you replace a water temperature sensor on an 1995 Buick lesabre?
Relieve coolant pressure. Unplug it. Unscrew it. Screw the new one in before any significant amount of coolant escapes. Connect the electrical connector to the new sensor. Consider replacing the thermostat.
How much coolant to fill a 1997 Saturn sw1?
The amount of coolant it will take to fill your vehicle is dependent upon how low the coolant level is. You can add coolant to your coolant reservoir. The reservoir will have an indicator of when the coolant system is full.
How much does it cost to replace a heater core?
The average cost for you to replace a heater core in your vehicle is close to $400. The amount will vary depending upon your vehicle and who you replaces it for you.
Where is the fuel pump on a 2000 Mazda Protege What is the average amount of labor involved to replace it?
In the fuel tank. 2.5 hours.
Why coolants are used in nuclear power stations and how much coolant is needed?
coolant is used to keep the reactor cool and prevent it from melting down. The amount of cooling that is required really depends on the the amount of heat being put into the coolant.
How do you change thermostat on a 1992 Chevy Suburban?
You most first make sure engine is cool. Drain 1/3 of coolant. Remove old thermostat. Clean area with acetone or isopropyl alcohol. Apply some RV sealant and put in new thermostat. Replace amount of drain coolant to appropriate level.
How do you clean out the water from the engine when doing a head gasket repair?
Drain the radiator, remove the head, drain the oil, replace the oil filter. Install the new gasket and replace the head. Add the correct amount of oil and coolant to the engine. Start the engine and bleed all air from the system.
What is the average cost to replace a 2 ton air conditioning unit?
the amount is around $2,500 How i know we had the same problem at my work..I paid for it with half my cheque
Why would my radiator not take the right amount of coolant I drained the coolant from the petcock and the lower rad hose When filling it back up it only took 8-9 quarts instead of 12 the 4.0 it should?
That number is the capacity of the coolant system. Even after the radiator is drained there is still about 3-4 quarts in the engine and heater core lines. to completely replace all coolant you will need to flush the system with water and consider the remaining water in the system into your 50-50 mix ratio.
