0
What is the best distributor rotor brand for Honda civic LX 2003?
Wiki User
∙ 12y ago
MSD w/ a rev limitor.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you change the distributor rotor button on your 98 Honda civic?
To change the distributor rotor on a1998 Honda Civic unplug the spark plug wires from the cap. Loosen the screws and remove the cap on the unit. Be sure to properly line the new cap on the distributor and install.
Where is the ignition control module on a 1994 Honda civic dx?
Inside the distributor cap under the rotor
What is the firing order from distributor cap to spark plug on Honda civic 1.5 procedure on timing a Honda Civic?
Firing order is 1-3-4-2 Rotor turns clockwise.
What else besides the distributor cap and rotor could cause starting problems in a 1995 Honda Civic?
Try the main relay. Mine was behind the glovebox on a 1996 civic. Good luck.
Where is the ignition coil in a 95 Honda Civic?
The coil is located in the distributor internally. If you take the distributor cap off and unscrew the rotor it should become visible. You may have to move a dust cover, but it is in there.
Where is the ignition module on a 89 Honda civic 1.5?
It is located under your distributor cap, behind the rotor. There are two bolts on the side of the distributor that must be loosened, take off the three wires, and it will come right out.
What is min thickness brake rotor 2010 Honda civic?
3
What is the minimum thickness for a 2001 Honda civic brake rotor?
19mm
Why does your 90 Honda civic sputter It wouldn't start replaced plugs wires and distributor rotor blade now it sputters and its not the ignition coil i replaced it HELP?
check and see if u have a hole in your muffler
How to find out if a 2005 Honda Civic LX has geuinge Honda front brake rotors?
there should be a Honda stamp on the inside center of the rotor
How do you remove the rotor to access the ignition coil for the Honda Civic?
a little 8 mill screw on bottom of rotor into dist shaft
How do you remove cap and rotor on 1992 Honda Civic 1.6 engine?
Loosen the screws on the cap and there is a single screw holding the rotor to the shaft
