Want this question answered?
Remove the tire and wheel from your 1994 Plymouth Sundance. Remove the brake assembly spring. The brake pads will come off. Reverse the process to install the new brakes.
20 amp square 2 prong fuse
Remove wheel if disc brakes: Remove caliper mounting bolts and slide caliper out of the way. If drum brakes: remove brake drum Remove brake line Hub assembly should be secured by 4 bolts You may have to separate backing plate from hub assembly, by supporting backing plate and striking hub assembly sharply w/hammer
Remove the grease cap in the wheel center. Then remove the cotter pin, and finally the nut. The brake drum should slide off. Remove the grease cap in the wheel center. Then remove the cotter pin, and finally the nut. The brake drum should slide off.
Auto supply store (I have have good luck with mid range)
Remove tire, remove brake drum, remove brake assembly housing, remove 4 bolts from back of hub assembly, gently tap to remove hub/bearing assembly.
Under the dash, driver seat side of the parking brake.
Remove hub cap, remove axle nut, raise and support front of vehicle, remove wheel, remove brake caliper and brake pads, remove caliper bracket, remove brake rotor, remove the three 15mm hex head bolts holding hub assembly to knuckle, remove hub assembly by tapping flange with a bfh. Reverse for assembly.
Master cylinder reservoir at driver's side firewall should have markings indicating full and low
remove wheel. remove brake caliper assembly(not the brake hose) and pull off the rotor.
Remove the tire and wheel. Remove the brake assembly and rotor. Remove the axle end cap. The rear hub assembly will come off.
Remove the wheel and tire assembly and the brake caliper then the brake rotor will slide right off.