100 in lbs.
2.7L doesn't have cam bearings. It has Cam towers. There is no Bearing in there. Look for torque of Camshaft Towers.
1300 citi golf cam shaft torque settings
"http://wiki.answers.com/Q/What_is_the_torque_spec_for_a_Toyota_22re_cam_bolt"
The 1987 Kia 1.8 liter engine had bolt torque specification is 120 pounds. The camshaft bolt torque specification is 90 pounds.
20 ft. lbs. as per other websites.
This is for a 2000 Kia Sportage. Camshaft cap bolt 16 lb-ft Camshaft Pulley Lock Bolt 42 lb-ft
4 steps. step 1 starting with the front center bolt then rear center bolt continue in a clockwise direction torque all to 25 ft.lbs. step 2 repeat at 50 ft. lbs step 3 repeat again to 50 ft.lbs step 4 same pattern additional 90 degrees to each bolt.
headbolt torque is : 62 ft/lb cam hold down bolts is : 13 to 20 ft/lb
The 1997 Geo 1.0 leader engine cylinder head bolt specification is 120 pounds. The camshaft bolt torque specification is 90 pounds.
Bolt pattern and torque specs are here: http://toyota.offroadforum.cz/aarc.epnet.com/application/8578/8578R03_Cylinder_Head.html
Get a manual; they are cheap and you will need it if you are that far into a build. - - - - - If you have a camshaft with a bolt-on gear, one or the other should have come with torque specs. Stock Type 1 cam gears are riveted to the camshaft.
Cam sensor on a 2006 Dodge Cummins is found just below the fuel injection pump. It is attached to back of the timing gear housing. It is attached with an Allen head bolt.