the 1990 corvette had the LT-1 motor 300bhp and 340fpt that is the correct answer to this question!
Pretty sure they didn't make corvettes in 1900. Maybe in 1990.
Our 1990 Corvette convertible weighs 3301 pounds.
where is the 1990 c4 fuse for the hore
The 1990 Chevrolet Corvette IAT sensor does have two wires. The sensor has a ground wire and a positive wire.
American Dreamer - 1990 Corvette Man 1-5 was released on: USA: 13 October 1990
No,the driver-side airbag premiered on the 1990 Corvette as standard.Also the passenger-side airbag premiered on the 1994 Corvette as standard too.
1 in tank.
your not ready for it if your asken on an online site
Under the engine on the passenger side.
No, not until the 1994 models.
A person can remove the front license plate cover on a 1990 Corvette with a screwdriver. The plate can then be replaced with a custom plate or a state plate if required.
The top speed of a Chevy Corvette ZR1 is 205 mph, or 330 km/hr.
To get a 1990 Corvette to start if it turns over and the battery is good, check to ensure the fuel filter is not clogged. You also need to ensure it has plenty of gasoline.
The 1990 Plymouth EGR valve is located on the outside of the air cleaner housing. The EGR valve can be found on the back side of the housing.
There is no egr valve on a 1990 Mazda MPV 6 cylinder
Use 2" adapters with 5X5 to 5x4.75 lugs. Make sure they are hub-centric, the more expensive ones usually are. This will give you the correct offset to match your truck. That is how I adapted 95 corvette wheels to my 1990 454SS truck.
Valve Amplification Company was created in 1990.