Overhead valves open vertically from the head into the combustion chamber. Overhead valve engines use a system of lifters, push rods, and rocker arms to operate the valves. The cam on an overhead valve system is adjacent to the crankshaft, and the lifters, push rods and rockers work together to operate the valves.
Overhead cam engines position the camshaft directly above the valves. In that position, there is much less weight of the valve operation mechanism, resulting in a potentially higher engine operating speed.
Mainly, the difference is that in an overhead cam engine, the camshaft is mounted on the head of the engine, and the valves are still overhead, in an overhead valve engine (sometimes called a "pushrod motor"), the camshaft is in the crankcase.
1990 is ka24e, single overhead cam, 1991 is ka24de, dual overhead cam.
Exhaust cam, is the cam that control valve timing on a DOHC, (DUAL OVERHEAD CAM) motor.
Under the valve cover, of an overhead valve engine. They push the rockers on the opposite side of the valve stems. Overhead Cam engines do not have push rods.
A high lift cam lifts an engine valve by a higher amount than a low lift cam.
If this is the (S.O.C) single overhead cam, there is no adjustments. The cam is worn, or there is a stuck valve, or broken valve spring. Hope this helps, GOOD LUCK!
The 4.7L is an overhead cam V8. The 4.0 is a push rod inline 6.
DOHC - Dual Overhead Cam. This means that there is an intake and an exhaust cam, allowing the valves to move differently for the intake and exhaust. SOHC uses a single cam with more lobes
Push rod.
The Z24 engine is an overhead valve engine and the Z34 is an overhead cam engine. The Z34's engine is pretty tight in it's engine bay so if you were thinking of doing a "swap", Z34 engine will not fit in the Z24.
I am not familiar with these terms. In 2008 three engines were available in the Outback. EJ253 is single overhead cam 2.5, EJ255 is double overhead cam turbo 2.5, and EZ30D is double overhead cam 3.0 six cylinder. According to Subaru no other engines were available.
single overhead cam Not true, it is cam in block design and over head valve (OHV).