Pre terminated wires may mean one of a couple things. At least to my knowledge.
Generally a pre terminated wire is a wire in use or that is connected thru in an operating device of some sort. The wiring in the state it came from the "assembly plant.'
Non-terminated wiring generally refers to wiring that is not in use or not connected yet.
"Terminated wires" are "connected wires."
Pre-terminated could also refer to some wiring that already has the "connectors" placed on the wire. Not just a bare wire w/o connectors.
Non-terminated could mean a piece of wire without "connectors" on it.
2.4
Cleat wiring is exposed while in conduit wiring the wires are well protected inside tubes/pipes.
There is a difference in the wiring and ECU between 96 and 97. I don't have a wiring diagram for them, but I believe most haynes manuals should have it. The 97 harness and ECU is a much more desirable setup if you intend to tune the engine since the 96 ECU is not supported by any aftermarket tuning programs.
none that i know of because the wiring diagram i have says its for a 74-75 cj5. but i have noticed a few wires on the chart are different than my stock wires on my jeep. so the only difference i would say might be some of the colors
potential difference
An elementary is a schematic or one line diagram showing the basic operation of a circuit and is best used for troubleshooting or discussing circuit operation. A wiring diagram shows point to point wiring connections, terminal points, component layout etc. and is used to connect and build a circuit.
yes.different plugs on several sensors and the plugs going into the pdc and ecu.
desktop goes on your desk cause its big it can also hold storages but needs lots of wiring but a laptop it the oppistie
The difference between 1 second and 3 seconds is 2 seconds. In terms of short-circuit withstand capacity, it can mean the difference between no damage and damage occurring to the equipment and wiring. Heat rises extremely fast in a short-circuit situation, and you want your protective device to trip before damage is done.
The differences between a 1992 E350 and a 1995 E350 transmission are in its mounting, gear ratio, and wiring. Both function in similar ways however they are not directly compatible with each other.
I can't say if there is a difference, but I will tell you this... Use the harness off your old engine, ya know, the one that came with the vehicle. I learned this lesson the hard way.
a lot of stuff an 88 is mostly vacume controled and a 90 is run on a ecu so basicly evry thing is dif