ARE YOU TALKING ABOUT THE Power Steering PRESSURE HOSE?? IF SO, I JUST HAD MINE DONE ON MY 1988 MAXIMA. IF YOU CAN GET UNDER THE CAR COMFORTABLY YOU JUST NEED BASIC TOOLS. THE HOSE IS FLEXIBLE AND LIKE A U SHAPE WITH TWO WEIRD ENDS ON EACH END OF THE HOSE.
Get a manual on your car from AUTOREPAIR2000.COM
remove front door panel 1995 Nissan maxima
How do I remove An 87 Nissan maxima gas tank
The easiest way to reset the 2004 Nissan Maxima computer is to remove the main fuse. Removing the main fuse for 10 seconds will cause the computer to reboot.
The easiest way to disarm your antitheft system on your 1988 Nissan Maxima is to remove the fuse. The antitheft system fuse location can be found on the inside cover of the fuse box.
Disconnect the negative battery cable.Drain power steering fluid.Loosen adjustment screw and power steering pump through bolt, then remove belt.Remove power steering pump union bolts and hose.
how to remove a power steering pulley on a 1997 Nissan altima
what year maxima? please email email@example.com In i can tell you how to do it..
twist then pull
the acutually dash removal of the Comfort-Control Toggle Switch in order to remove facing for radio replacment of 1990 nissan maxima?
remove the whole front end
To remove the harmonic balancer from a Nissan Maxima, first you need to removed the center bolt. After that, you can use a puller to remove the harmonic balancer. Before you do this, make sure you disconnect the battery and remove the drive belts.
Filters for a Nissan Maxima need to be changed every 15,000 miles. To change it remove the screws, release the retaining clips, and remove the glove box bulb.
you pull it out you pull it out
To remove a 1993 Nissan maxima rear speakers you will have to remove the seat back, you will need a wrench to remove both of the bolts on each side. The seat will move once done, and then pop the parcel shelf trim. The speakers should come out.
remove s.w.cover ,remove bolt,use s. w.remover
How do u remove break light sensor
To install the alternator on a 1996 Nissan Maxima you will have to remove the drive belt first and then the A/C compressor. Do not remove the refrigerant lines because the compressor will only have move down about a few inches for you to get enough room to remove the alternator. The alternator will need to be taken out from the bottom.
Can figure out how to remove rear rotor assembly to replace wheel bearing assembly on a Maxima 2004 Nissan
I need a step-by-step how to change, remove and replace an alternator in an 1996 Nissan maxima
It is in the console, remove the panel where the passenger's left foot would be.
Easiest way is to remove the bed. Then you can remove it without dropping the tank.
Take off the sockets and remove the pump pulley.
You have to remove the front bumper, remove the headlight assembly. then take the fog light bulb out.