an evaportor is to absorb heat in the room and to keep it cool,to release the hot air outside in the atmosphere
The primary purpose of air filters is to keep the blower and evaporator coil clean. You should clean your A/C filter often to reduce unnecessary energy consumption.
to heat a space. the ducts move from the evaporator(a/c) to the heater core, where the core has hot antifreeze going thru it and a blower motor blowing across it produces heat
The Evaporator is the part of a refrigeration system that absorbs heat. Its counterpart is the condenser which is used to remove heat that was absorbed in the evaporator.
The evaporator is cold.. heat flows to a colder object.
On the evaporator case.
Under the hood on the evaporator case.
There is only one blower motor resistor and it is located in the evaporator housing.
The evaporator on the Ford Mustang is located between the dash and the firewall. Dash removal is required to remove the evaporator for replacement. The dealer replacement evaporator comes with the evaporator housing. The intake air assembly, blower motor, blower resistor, actuators, heater core, etc., have to be switched to the replacement housing. There is a photo on Honda Man's Bio page with the dash removed and the evaporator housing placed on the rear of the car.
;slow blower;low on freon;dirty filter.
On the evaporator case.
It is attached to the back wall of evaporator. You have to remove the glove compartment, blower unit and evaporator to get access to the expansion valve.
remove the blower motor and black box in the engine bay by the blower motor. these evap. cores do leak on the g20s
If you are referring to the blower motor resistor then it is inside mounted on the evaporator case.
It can be the resistor pack on the evaporator case.
The function of the evaporator is to cool the air by absorbing heat into the refrigeration system.
It is on the evaporator case and is held in with 2 screws.