0
What is the ground wire for that attaches to the fuel filler line?
Wiki User
∙ 12y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why a gas smell 1994 Toyota 4runner?
there was a recall done on this car as i had one. problem with fuel filler hose. take to dealership. done for free. if this has been done then u need to check the rubber fuel hoses as they tend to go bad. i had to replace a few of those two. third possibility is bad fuel injectors that are leaking. dont wait. dangerous. Have your gas line checked. It could have a small hole in it. I had the same problem with my car. The gas line was cracking. I change the gas line, the smell went away.
Is transmission voltage a phase to phase voltage or a phase to ground voltage?
Phase to Phase voltageCorrection to the above answer:There is no such thing as a 'phase-to-phase' or 'phase-to-ground' voltage. The correct terms are 'line-to-line' (or 'line voltage') and 'line-to-ground' (or 'phase voltage'). Transmission-line voltages are line-to-line (or 'line') voltages.
Why is the equator imaginary?
It is a concept, not a physical thing. There is no line painted on the ground and ocean to show where the equator is, just as there is no line on the ground to show a state line.
1979 ford f100 fuel tank theres a green wire and a black wire where does the black wire go the green wire is hooked up but not the black one?
One wire goes to the sending unit in the tank. It should hook to a terminal beside where the fuel line connects. The other one grounds out the body of the sending unit or the whole plate where the fuel line goes into the tank. 3-4 inch round plate. The ground wire will either go into the wire harness with the sending unit one or ground directly to the frame. The ground wire on all gas tanks very often rusts off.
What is phase to ground fault?
There will a only one phase on home electricity.AnswerThere is no such thing as a phase-to-phase-to-ground fault'; the correct term is 'line-to-line-to-ground fault. It occurs when two or more line conductors make contact with each other and to ground; for example, when a JCB accidentally cuts through a three-phase cable.
How do you empty petrol from line trimmer?
open the fuel tank filler cap and dump the fuel/oil mixture out.
Where is pressure regulator on 95 mercury villager?
If you mean the fuel pressure regulator, it's on the end of the fuel rail near where the fuel line attaches.
Why does the fuel splash out of the car?
did you forget to replace the cap on the filler tube ? or you may have a leaking line
How do you siphon gas from a 2007 Ford Escape?
You have to undo the filler neck or pull off a fuel line.
How do you change a fuel pump in an 1996 Chevy Corsica?
the vehicles fuel tank must be removed. There are two 15mm bolts holding the fuel tank straps to the car. There are three fuel lines attached to the fuel tank sending unit, a feed line, a return line, and a vapor line. There are also two large hoses for the filler neck, the filler itself and the filler vent. It is recommended that you get help to lower the fuel tank down if it is more than a quarter of a tank full. Once down, remove the lock ring holding the sending unit in the tank. From this point, the fuel pump is visible. Installation is reverse of removal.
How do you find a fuel pump on a 1984 corvette?
The fuel pump is located in the fuel tank, attached to the fuel gage sending unit, and may be serviced separately. Access is through the fuel filler door in the body.Replacement proceedure1. Disconnect battery ground cable. 2. Remove fuel filler door.3. Remove fuel cap.4. Remove the rubber fuel tank filler neck housing and disconnect drain hose.5. Remove screws attaching fuel meter/fuel pump to tank.6. Disconnect fuel lines, fuel vapor line and electrical connector.7. Remove fuel meter/fuel pump and gasket.8. Replace fuel pump.9. Install replacement unit in reverse order.
How do you change fuel pump on 1984 corvette?
The fuel pump is located in the fuel tank, attached to the fuel gage sending unit, and may be serviced separately. Access is through the fuel filler door in the body.Replacement proceedure1. Disconnect battery ground cable. 2. Remove fuel filler door.3. Remove fuel cap.4. Remove the rubber fuel tank filler neck housing and disconnect drain hose.5. Remove screws attaching fuel meter/fuel pump to tank.6. Disconnect fuel lines, fuel vapor line and electrical connector.7. Remove fuel meter/fuel pump and gasket.8. Replace fuel pump.9. Install replacement unit in reverse order.
Where is the fuel pump on a 1984 Corvette?
The fuel pump is located in the fuel tank, attached to the fuel gage sending unit, and may be serviced separately. Access is through the fuel filler door in the body.Replacement proceedure1. Disconnect battery ground cable. 2. Remove fuel filler door.3. Remove fuel cap.4. Remove the rubber fuel tank filler neck housing and disconnect drain hose.5. Remove screws attaching fuel meter/fuel pump to tank.6. Disconnect fuel lines, fuel vapor line and electrical connector.7. Remove fuel meter/fuel pump and gasket.8. Replace fuel pump.9. Install replacement unit in reverse order.Read more: How_do_you_replace_fuel_pump_on_1984_corvette
Where is the fuel pump for a 1984 corvette?
The fuel pump is located in the fuel tank, attached to the fuel gage sending unit, and may be serviced separately. Access is through the fuel filler door in the body.Replacement proceedure1. Disconnect battery ground cable. 2. Remove fuel filler door.3. Remove fuel cap.4. Remove the rubber fuel tank filler neck housing and disconnect drain hose.5. Remove screws attaching fuel meter/fuel pump to tank.6. Disconnect fuel lines, fuel vapor line and electrical connector.7. Remove fuel meter/fuel pump and gasket.8. Replace fuel pump.9. Install replacement unit in reverse order.Read more: How_do_you_replace_fuel_pump_on_1984_corvette
How do you remove the fuel pump on 1984 corvette?
The fuel pump is located in the fuel tank, attached to the fuel gage sending unit, and may be serviced separately. Access is through the fuel filler door in the body.Replacement proceedure1. Disconnect battery ground cable. 2. Remove fuel filler door.3. Remove fuel cap.4. Remove the rubber fuel tank filler neck housing and disconnect drain hose.5. Remove screws attaching fuel meter/fuel pump to tank.6. Disconnect fuel lines, fuel vapor line and electrical connector.7. Remove fuel meter/fuel pump and gasket.8. Replace fuel pump.9. Install replacement unit in reverse order.
How do you replace fuel pump on 1984 corvette?
The fuel pump is located in the fuel tank, attached to the fuel gage sending unit, and may be serviced separately. Access is through the fuel filler door in the body. 1. Disconnect battery ground cable. 2. Remove fuel filler door. 3. Remove fuel cap. 4. Remove the rubber fuel tank filler neck housing and disconnect drain hose. 5. Remove screws attaching fuel meter/fuel pump to tank. 6. Disconnect fuel lines, fuel vapor line and electrical connector. 7. Remove fuel meter/fuel pump and gasket. 8. Replace fuel pump. 9. Install replacement unit in reverse order.
How do you fix a fuel blockage in my xf falcon?
remove fuel delivery line from fuel filter,remove fuel filler cap,blow compressed air back down fuel line to fuel tank.dont allow vehicle to run out of fuel,as it may pick up settlement from bottom of fuel tank.
