== == On my 1995 Ford Explorer 4.0 L OHV ( same engine ) from end of " blade " to the plastic cap on the dipstick is ( 21 and 3/8 inches )
The length of the transmission dipstick that goes in a Chevy LuminaÊ3.1Êmotor is 24 inches. This is a common size for the 3.1 engine.
if the diameter of cylinder and stroke length of an I.C. engine is greater then the power output is more.
if the diameter of cylinder and stroke length of an I.C. engine is greater then the power output is more.
if the diameter of cylinder and stroke length of an I.C. engine is greater then the power output is more.
My 1995 Ford Explorer 4.0 L OHV engine ( which takes 5 quarts with filter change ) has an oil dipstick ( 21 + 3/8 inches long ) from the end of the " blade " tip to the plastic " cap " on the dipstick My 1995 Ford Explorer 4.0 L OHV engine ( which takes 5 quarts with filter change ) has an oil dipstick ( 21 + 3/8 inches long ) from the end of the " blade " tip to the plastic " cap " on the dipstick
B. 127
168.8 cubic inches
I wouldn't recommend it. there isn't a way for you to know exactly how much oil is in the engine unless you had previously found the length and the measurements of the markings on the dipstick.
The 1985 Chevrolet El Camino dipstick length is 27 inches. The dipstick needs to be exact in order to measure the oil properly.
Engine cylinder capacity(Engine cylinder volume )is represented by cubic centimeter(cc).CC is calculated by the following formula CC=N*((π*d^2*l)/4) N=no.of cylinder d=cylinder dia l =stroke length
Likely if it's the same engine, but best ask a mitsu dealership, they can compare part numbers
Correct, there is no one dipstick that will fit all vehicles. What you need is a dipstick that is the correct length. If you have lost yours, then go to your local salvage yard and find a car with the same engine. Ford Contour, Mercury Mystique, Ford Mondero, are all the same. Look for one with the same engine, either the 2.0 or 2.5. The dipstick from any of these will fit. Another alternative is to get any dipstick that will actually fit and be long enough. Drain your oil and change the filter. Add the correct amount of oil that is required for an oil & filter change. Start the engine and run for 1 minute. Shut the engine off, Wait one hour and check the level on the dip stick you are using. Mark the level of the oil on that stick, and use that as the full mark. This way you can make your own dipstick.