The first thought is the turn - hazard switch in the steering column. But starting from the beginning, you need to verify the turn fuse is good. This should be a yellow 20 amp , also check the stop/hazard fuse. Again this is a yellow 20 amp. Next you need to check for 12 volts at the orange wire of the hazard flasher plug. This needs to be 12 volts at all times. Next turn the key on, and check for 12 volts at the pink wire of the turn flasher plug. Also do the brake lights work? The brake lights run off of the hazard fuse also. If the brake lights work, try the lights with the key on and the turn signal switched left and right. If the brake lights work but go out when you turn the switch left or right and you verified all the above you need a new signal switch in the column. I hope this is helpful
Probably the turn signal flasher
Bad switch in steering column? diffrent fuses.
There is two flashers involved, one for the signals and one for the emergency flashers. Perhaps you changed the wrong one.
You may have a relay problem your flashers and turn signal are on different relays or there could be a problem with the wiring in the steering column that goes to the turn signal
Defective flasher module - common problem
Could be the bulbs or the fuses or the flashers or the signal switch assembly
No turn signals are not by law required, as long as you have your headlight, brake light, and you know the hand signals for turning on a bike than you don't need flashers. But if you're not using flashers, you are still required to use hand signals
Check bulbs they are double filamented smaller for brake/ turn signals Check the sockets for corrosion Check for power and ground to sockets Could be a problem in the steering column switch
yes
Probably a wiring issue between the turn signal and the lights.
i fnone of the turn signals work, the first placeto look is the flasher can. this is a clyander usually located in or near the fuse box. there are 2 of these.1 is for turn signals, other is for 4 way flashers
Often, a separate flasher unit is used to activate the hazard flashers. This unit might be bad, or the switch to activate the hazard flashers might be bad. answer always there are 2 flashers.one for turn signals other for hazard replace hazard flasher They have separate fuses also.