0
What is the rear differential pinion nut torque specson a ford 9 inch?
Wiki User
∙ 13y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the rear differential pinion nut torque specs?
What is the torque specs on a 2001 ford truck rear end pinion nut..
How do you replace rear differential pinion bearing?
trying to replace rear pinion bearings 1993 ford aerostar, 7.5 rear differential...slinger washer on drive shaft side is stuck, cant get pinion shaft out, all differential parts have been removed...any suggestions?
What is the preload on the pinion bearing and the backlash on the crownwheel and pinion inside the rear differential of a 1997 ford explorer 4 wheel drive?
The shim between the inner bearing and the pinion is critical and if it's lost you need special tools to set the pinion depth. replace the bearings and seal with an new crush sleeve thighten the pinion nut until the sleeve crushes and you can't move the pinion up and down. Then very slowly tighten the pinion nut checking the rotational torque. You will need an inch pound torque wrench, when the preload is correct it should take between 20-25 inch pounds of torque to rotate the pinion. If you get it too tight you need to replace the crush sleeve and start over. Proper bearing preload and gear mesh are critical.
What is torque specs for ring gear on ford 9 differential?
THE TORQUE SPEC IS 75FT/LB USING ARP BOLTS
What to do if your Ford f 150 is leaking fluid from differential yoke?
The pinion seal is shot. A mechanic can replace the seal and check for problems.
What is the torque spec for a rear differential cover on a 2000 ford ranger?
the recommendation for the differential housing cover bolts is 16 ft. lbs.
What is the torque spec for the bearing caps on a 2004 ford 9.75' rear differential?
77ft lbs
What is the preload on the pinion bearing and the backlash on the crownwheel and pinion inside the rear differential of an English 1970 ford escort?
If this helps the sailsbury axle of a cortina details are crownwheel and pinion backlash 0.004-0.008" pinion bearing preload 0.001-0.003" collapsible spacer length 0.453-0.461".
What is 1995 Ford pick up with traction lock rear pinion nut torque?
The only torque you should be concerned with is the torque it takes to rotate the pinion gear alone, 8-14 inch pounds for old bearings, 16-29 in/lbs. for new bearings. The torque it takes to crush the crush collar (tightening the pinion nut) will be above 140 foot lbs. and this will set your tension on the pinion bearings. If you put a new crush collar in you are going to have to remove axles and carrier to get the proper pre-load on the pinion bearings.
What are the differential torque specs on the rear end of a 2003 Ford F150?
29-33 ft. lbs.
What is torque spec for 2003 Ford Escape rear differential yoke?
23nm/17 ft-lbs
Why would a Ford explorer jerk while driving?
Your Pinion seal on the drive shaft and rear differential need to be fixed.
