O= valve springs += head bolts 8 6 1 3 9 + O + O + O + O + passenger side of motor + O + O + O + O + driver side of motor 10 4 2 5 7 this is the sequence from my haynes manual. i tried to emulate the diagram the best i could with the keyboard. the front of the motor is on the left. hope it helps and good luck.
The 1994 Toyota pickup truck starter mounting bolts can be found on the head of the starter. There will be three mounting bolts.
Remove the bolts from any supports bearing carriers. Remove the bolts from any U-joins assenbly's and the drive shaft will fall out with a little wiggling on your part. Doing this procedure backwards can damage any attached support bearings and or carrier assemblies.
Most GM truck frames in that vintage use two straps around the tank. The tanks have bolts for tightening. Look about halfway up the side of the tank on the center of the truck.
Torque as follows 53-63 ft/lbs. in 3 steps
the cluth fan bolts right up to the water pump mounted on the block
Toyota V6 1989 Oxygen senson is located on the driver side in front of the catalytic convertor. It has four wires and held on by 2 bolts.
One of the best Toyota used truck is the Toyota Hilux. In other countries, the Toyota Hilux is marketed as the Toyota Tacoma.
Yes
that depends on the motor that it has.
replaceing windshield wipers toyota truck
Of course it will. You can put any bed from any truck on any other truck. A bed is a bed is a bed.
it depends what truck your talking about, Year and Model. Mos of them are 6 bolts and are 6x139.7, then the 5 bolt trucks are 5x114.3. I dont know of the older ones but I would assume its the same as the 6 bolt pattern