6 to 8 degrees advanced. for stock compression ratio.
You don't because anyone who owns a ford should not put a Chevy motor in it.
yes
my 56 inline 6 is on fly wheel back of engine look thru hole above starter, tdc is a small ball like a bb
no yes a bb Chevy bell housing can fit a sbc. but you should remember that 10 in or a 10.5 in bell housing will not fit an 11 in pressure plate. Just make sure that the bell housing will fit the pressure plate and you'll be just fine.
1971-1972, manager, financial analysis department
The red ryder no 111 was made from 1939 to 1971. Then it became the 1938 model from then on to today
The Daisy model 225 was made by Milbro of Scotland for Daisy between 1971-1974
"How to Rebuild the Big Block Chevy V8 Engine" Book has that info
Depends on what size small block or bb chevy. Cast iron or aluminum. All of these must be taken into consideration.
in a Bb x bb cross?
Bb, Bb, C, Bb, Eb, D Bb, Bb, C, Bb, F, Eb Bb, Bb, Bb(up an octave), G, Eb, D, C Ab, Ab, G, Eb, F, Eb
Bb Bb C Bb Eb D Bb Bb C Bb F Eb Bb Bb Bb G Eb D C Ab Ab G Eb F Eb