Legacy was never available with 1.8 litre motor. Legacy has no distributer. Legacy uses direct ignition. Legacy timing is computer controlled and not adjustable. loyale was only available with 1.8 litre. If you have 1991 Subaru and you are sure the motor is 1.8 litre your subaru is a called a Loyal and is a piece of junk that nearly destroyed the subaru name. Get rid of the Loyal and buy a good used Legacy. Yes, make certain you have a Legacy and not the smaller Loyale-- Legacy has a more rounded nose, and Loyale has sharper edges. If you have a Loyale, (or are overseas and have a Loyale motor in a Legacy), the timing setting is approx 20 degrees BTDC if you have fuel injection (single or multiple injectors), or approx 8 degrees if you have a carburetor.
The water pump on a 1991 Subaru Legacy is in the engine compartment. It is found at the base of the engine.
The 1991 Subaru Legacy has a 4 cylinder 2.2L engine
how do you replace the fuel injectors on a 1991 subaru legacy
In general, many of the 1990 through 1993 parts are interchangeable on the Subaru Legacys. But your best source would be a 1991 Subaru Legacy, followed by a 1990 Subaru Legacy. Verify the bolt patters before purchasing from 1992 or 1993.
In a 1991 Subaru Legacy, the speed sensors can be found on the driver's side of the transmission. They are located towards the rear, and there are three of them.
If you have no spark on the 1991 Subaru Legacy, you should check the spark plugs and spark plug wires for replacement. You should also check the battery and ignition for replacement.
goto subaru dealership and have it adjusted by experts.
Check the 1991 Legacy for a stuck thermostat. Check to make sure that the water pump is working properly.
15.9 US Gallons.
Top, front, center, under the plastic cover.
it doesn't have one the alternator is regulated in side
About every three thousand miles.
Have you put you foot on the foot brke as you mover the shifter.
40wt transmission fluid 40wt transmission fluid
4.2 w/ filter
Code 33 means: Vehicle speed sensor (VSS) or circuit
To make room and carry more things, or carrying lumber, ladders as example.
head gasket blown. reface the cylinder head and replace gasket. that should fix the problem
Open bonnet. Facing car, look at about '11 o'clock' by firewall. Good Luck
there are timing marks on both cam pullys and a timing mark on the crank pully as well. you have to have them all aligned to the marks on the inner timing cover, which is virtually strait up and down on all three. and you must also match the timing lines on the new belt up with the timing marks on the pullys. be sure not to roll any of the pullys backwards (counterclockwise) or you could cause some major valve damage.
Should be on the Pass. side of dash above your right toe if you are sitting in the seat. 3 or 4 screws and it drops out.
ok 1990-1994 subaru legacy engines are basically the same the water pump on mine 1991 is located on the thermostat housing on the bottom of the engine on the lower tube off the radiator so find your lower radiator hose follow it is should go to the thermostat and the water pump is on that