answersLogoWhite

0


Best Answer

In a 1991 Subaru Legacy, the speed sensors can be found on the driver's side of the transmission. They are located towards the rear, and there are three of them.

User Avatar

Wiki User

โˆ™ 2014-09-17 19:44:22
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Where is the speed sensor on a 91 subaru legacy?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What cars bolt pattern is 14 5x100?

subaru 91-legacy


How do you get the timing specs for a '91 Subaru Legacy 2.2 eng?

A repair manual


Will a 91 Subaru legacy auto transmission fit in a 90 Subaru legacy?

the 1989 through 1993 subarus were one series. should bolt on so long as the engine is the same model.


Where is the fuse for a 91 Subaru Legacy horn and cruise control?

look on the drivers side kick panel


Where is PCV valve on 91 subaru legacy?

it is screwed in to the intake maifold on the air box side of the engine


Where is the speed sensor located on a 91 geo prizm?

The 1991 Geo speed sensor is located on the side of the transmission. The speed sensor will be on the left-hand side of the transmission.


Where is the speed sensor located on a 91 Chevy Beretta 3.1L?

There is no such thing!!


Where is the speed sensor located on a 91 firebird?

on the transmission tailshaft housing


Where is vehicle speed sensor located on 91 Honda civic '?

in the ecu


What does the VSS do in a 91 Honda Accord?

The VSS (Vehicle Speed Sensor) moniters the speed of the vehicle.


Does a 1994 Chevy S-10 have a Speed Sensor or a Cable?

I have a 91 s10 and it has a speed sensor. It is located at the rear of the tranny on the drivers side


Where is the speed sensor on a 1991 crown vic?

oN THE 91 FORD CROWN VICTORIA YOU WILL LOCATE THE SPEED SENSOR ON THE DRIVERS SIDE OF THE TRANSMISSION ON THE TAIL SHAFT.


Crank bolt on 91 Subaru Legacy is it reverse threaded?

No! you should use a chain wrench to hold the pulley from turning,lefty loosy, righty tighty!


Where is the signal relay on a 91 subaru legacy wagon?

with all the other relays in the fuse/relay box in the engine compartment in front of the left wheel well.


Where is the top speed sensor on a 91 lumina v6?

Never heard of a top speed sensor. Vehicles are usually governed by the computer. The only way to remove the governor is to have the computer reprogrammed.


Where is the speed sensor located on a 1994 cutlass ciera?

where is cam senor on a 91 cutlass ciera 3300


Where is the temp sensor on a 91 Chevy Astro?

Where is the temp sensor on a 91 Chevy astro


If you have a Mazda Protege '91 which has a hold light blinking and the speedometer does not work what is wrong with it?

it could have a bad speed sensor


Why does cruise control control high idle but not road speed 91 Peterbilt 379?

The engine computer is not getting a road speed sensor reading.


Where can you find the crank sensor on a 91 sunbird 3.1?

Where is crank sensor on 3.1 v6 91


Where is the 91 Plymouth Acclaim speed sensor?

it is on the back of the transaxle of the transmission its an oval piece with a two part wire going into it.


Where is the radiator bleeder 91 subaru legacy?

On the top left hand side of the radiator there is a square screw-in plug with a Philips head. Take it out while filling the radiator to let the trapped air out.


Where is the speed sensor on a Honda 91?

The speed sensor on the 1990 to 1993 Accords is on top of the transmission differential. Look directly below the throttle body and you will see a large grey box with wires coming out of it. That box sits on top of the transmission differential. That is the speed sensor. There are three 10mm bolts holding it down.


Where is the speed sensor on a 91 Honda accord lx 4dr with a automatic transmission?

the speed sensor is on top of the transmission by the rear firewall. it is under the fuel injector and under a couple of hoses but you can see it it only has two bolts holding it on


How do you replace a broken key in a 91 subaru ignition?

To replace a broken key in a 91 Subaru ignition, you will need to contact a locksmith. The locksmith can cut a key to match your ignition.