Want this question answered?
front hub 120nm i think
Actually the nut does not hold the rotor on. Your brake caliper does that. The nut holds the front hub on. correct and the torque setting for the front hub nut is ..284 ft pounds
chevy cobalt torque specfront hub
If this is the European Ford Focus Front hub nut torque is 300-332Nm.
Hub and bearing assembly and tighten the bolts to 61-78 ft. lbs. (83-107 Nm)
The hub nut is 137 ft lbs......... The two lower bolts and nuts that the strut mounts to wheel assembly is 167ft lbs......... Dont over torque that hub nut you will have problems.......................
Front wheel bearings are pressed in using a hydraulic press, no torque setting. However, the wheel hub retaining/axle nut that you need to remove and replace in order to change out the bearing needs to be torqued down to 233 ft-lb.
The 2000 Ford Explorer front hub nut has a torque specification of 140 pounds of pressure. The hub should not be over tighten. Over tightening can ruin the seal.
1992 - 1997 Hub Nut Torque is 107 ft-lbs
90 to 100 lbs
170 pounds
See the link here: